User- and installation manual for BioLet 55 and 65 ® HOW THE BIOLET WORKS Biolet is a selfconutined biological toilet that composts waste, toiletpaper and evaporates liquid. The composting process takes place using nature's own microorganisms, without the need of any chemicals.The toilet should be used as any other.
Your Biolet box and installation kit The box contains: The toilet, bag of humus, rake and manual. Optional Roof Installation kit Ventilations pipes 1100mm (43") x 4 pcs. Exterior pipe 1000 mm (39'') x 2 pcs. Insulation x 1000 mm (39") Reduction coupling 55/ 110 mm (2 1/4"...
Required floor space BioLet 55 width 55 cm (2 1 1 /2") x length 11 0 cm (43") (toilet and room for removing tray) BioLet 65 width 65 cm (25 1 /2") x length 1 35 cm (53") (toilet and room for removing tray) Pipe installation The entire pipe, from ceiling and up through cold areas such as attic, must be insulated.
MAINTENANCE Capacity setting ADJUST CAPACITY BY TURNING THE KNOB The recommended start setting for 2 people using the toilet is step 2. After 1-2 weeks in operation, you might have to adjust the setting depending on the liquid level in the tube (21). lf the tube is empty, decrease the setting and if the tube is more than half full increase the setting.
MIXING MIXING When using the toilet, the mixer-motor is activated automaticly by the compost cover. When using the toilet, the mixer-motor is activated automaticly by the compost cover. The waste and paper will be mixed into the compost. The waste and paper will be mixed into the compost. EXTRA GUESTS EXTRA GUESTS Add a couple of litres (quarts) of humus starter.
– What to do if the compost becomes too dry? The forming of hard lumps or that toilet paper remains on top instead of becoming wet and getting mixed in to the compost indicates that it is too dry. There should be about 1 cm(1/3") of liquid in the level tube (21). Use the setting to reduce the heat to a lower level and spray a couple of litres (quarts) of water on the compost, at the same time mix the compost through the seat opening using the rake.
– What do I do if the mixer motor does not work? – What do I do if the mixer motor does not work? The motor starts and stops and after a while it starts again and the mixing arms are still not moving! The mixer motor is activated at each visit.
Page 10
Designed & Manufactured by Swedish Ecology AB Klippan 1J S-414 51 Göteborg Sweden Tel: +46 31 42 29 30 Fax: +46 31 42 49 08 info@mulltoa.com www.mulltoa.com...
Need help?
Do you have a question about the BioLet 55 and is the answer not in the manual?
Questions and answers