UEi ONE FOR ALL SMART CONTROL PRO Quick Start Manual

ENGLISH |
FRANÇAIS
URC 7966
SMART CONTROL
PRO
I
II
III
4 X AAA
IV
WARRANTY
WARRANTY / GUARANTEE INFORMATION
Terms and Conditions for "100% Guaranteed To Work" policy, and the seperate
1 Year Limited Warranty against defects in material and workmanship can
be found at www.oneforall.com/remoteguarantee, or you may request hard
copies by calling 855-716-2573, or via mail to UEI Technical Support Service,
Suite 301, 26250 Euclid Ave., Euclid, OH 44132. Please include your full name,
product information, and contact information in your request communication.
LEGAL NOTICES
FCC STATEMENT:
FCC ID: MG3-117966
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interferen-
ce that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
www.oneforall.com
Customer Support: 855-716-2573 (toll free)
OFA warranty/terms & conditions:
855-569-6595 (toll free)
www.oneforall.com
Imported into the US by:
Universal Electronics Inc. One For All is a registered trademark of UEI,
UEI Technical Support Services,
Suite 301 26250 Euclid Ave. Euclid,
OH 44132
INDUSTRY CANADA REQUIREMENTS
ISED ID 2575A-117966.
This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference and (2) this device must accept any interference, including
interference that may cause undesired operation of the device
CANADA RF EXPOSURE COMPLIANCE
To comply with RSS -102 requirements, a separation distance of 15 mm must
be kept between the device and the user at all times.
CANADA RF EXPOSURE COMPLIANCE
This product complies with the FCC/IC RF Exposure for Low Power Consumer
Wireless Power Transfer. The RF exposure limit set forth for an uncontrolled
environment and are safe for intended operation as described in this manual.
The furthest RF exposure that compliance was demonstrated at 15mm and
greater separation from the user body or set the device to lower output power
if such function is available.
If you need help at any time during setup, please use the Virtual Agent in the app.
Connect with us
Made in China, Hecho en China
facebook.com/
RDN1200623
oneforallworldwide
Problems pairing?
Scan the QR code below for help
Virtual Agent
@oneforall.worldwide linkedin.com/ youtube.com/
company/one-for-all-worldwide/ user/oneforallproducts