Tim-UTE
1111 W. 35th Street
Chicago, IL 60609 USA
Customer Support* (773) 869-1234
www.ltripplite-com
Owner's Manuaf
•EURO-4
• ISOBAR 4/220
•CCIEURO
Isobar® Surge Suppressors
(
220
/
240
V)
Isobar Surge Suppressors protect attached equipment against potential damage from
sp^es, si^ges^d noise interference on the AC line. All models feature durable metal
cabinets. EURO-4 and ISOBAR 4/220 models feature isolated filter banlcs which eliminate
interference between connected equipment. CCIEURO models are designed to be located
between a computer and monitor for easy access to front panel switches.
INSTALLATION
STEP 1) Using the supplied power cord, connectthe surge suppressor to a grounded
three-conductor 220/240 Volt, 50 or 60 Hz AC wall outlet.
Note: the
Isobar4/2m
te designed for
230V
operation, but may also be used for
120V
operation (at reduced suppression
levds).However,.ttstheuser'sresponsibaity,toavoidequipmentdamage,tobesuiethevSSffira^oTZ^ed
^mpmenl mahhes the voltage deUveted at their AC waU outlet Select s^e suppressor model
a detachable
^muX
power cord from your equipment^oi
a computer for example) with a plug type that matches your wall outlet
^
^ ^
^
^UnON! Do not connect the surge suppressor to a UPS system's output receptacles
All cords, adapters or wall outlets must have a ground pin or connection. LaA of a
proper ground connection will eliminate common mode protection.
STEP2)Connectyourequipment(either2-or3-wire)tothesurgesuppressorsoutput
receptacles.
not match the surge suppressor's receptacles, use an IEC-320jumper cord (supplied
l.Tripp.Lite"
^
" Universal Plug Adapter (available separately in a variety of plug co^lfiguraHonf tom
CAUTION! Do not connect equipment with a total amperage rating higher than the
Mperage ratmg of the surge suppressor's circuit breaker (see Specifications on back).
U the amperage rating is exceeded, the circuit breaker will trip. Remove overload; wait
i
mmute; and press circuit breaker to reset.
STEP 3) Turn on the surge suppressor's power switch.
WARNING! Do not drill into or open any part of the surge suppressor. There are
'"01'ages present inside the unit. There are no user-serviceable parts inside
Copyright © 2G0Q by TB/PP-UTE All rights
resen'ed. Isobar® is a registered trademark of Tripp Ute.
Need help?
Do you have a question about the EURO-4 and is the answer not in the manual?
Questions and answers