Armrest Installation Insert screws into the screw holes on the support rods. Insert the screw of the support rod into the corresponding screw hole of the armrest and tighten it with the Allen Wrench (Note: the other side is installed the same way). Install the front Install the rear support rod...
Actuator Installation Install the power end of the actuator on the front support rod, and install the rear part of the actuator on the seat. Insert the latch and fix the R-shaped clip in the clip hole. Seat Cushion Installation Have the seat frame worn the cushion, started from the bottom side.
Page 8
All Motors Random Up&Down Side Tapping Zig-Zag To Side In & Out Strength+ Strength- Upper back Lower back Waist Seat Calf Zero-G1 Press this button to adjust the chair angle to Zero Gravity level 1 Zero-G2 Press this button to adjust the chair angle to Zero Gravity level 2 Zero-G3 Press this button to adjust the chair angle to Zero Gravity level 3...
Need help?
Do you have a question about the R5J04IVY and is the answer not in the manual?
Questions and answers