Summit SU85302 Instructions Manual

20' steel climbing stick

Advertisement

Available languages

Available languages

Summit 20' Steel Climbing Stick
Instructions
SU85302
!
WARNING
Do not use this product until you understand safe and proper use. You must read and follow all instructions and warning prior to each use! Store these
instructions in a safe place and review periodically and at least yearly. Ensure that all users have reviewed these instructions before any use.
A FBFAHS is not included with this product. However, this product is intended to be used at all times with a FBFAHS. A FBFAHS must be worn and
connected to the tree at all times after leaving the ground when using this product. This product should only be used with treestands that have been tested
and certified to meet or exceed standards recognized by the Treestand Manufactures Association (TMA). These treestands are sold with harnesses
(FBFAHS) equipped with lineman's climbing belts that have been tested and certified to meet the requirements of Test Method F2337. These FBFAHS and
lineman's belts allow the hunter to be connected to the tree at all times after leaving the ground. If you do not have a FBFAHS, do not use this product.
When used herein, "treestand" includes tripods, climbing stands, fixed position stand and ladder stands.
When hunting from a treestand, falls can occur any time after leaving the ground! Any fall can cause serious injury or death! The use of a full body fall
arrest harness system (FBFAHS) is required when using any treestand. If FBFAHS is not present, hunt from ground level!
The use of this product requires the use of a full body fall arrest harness system (FBFAHS) that includes a lineman's climbing belt. A lineman's climbing belt
allows the user to remain attached to the tree through climbing and descent so that they may remain attached to the tree from the moment they leave the
ground until they return to the ground. The FBFAHS must be used and attached to the tree prior to gaining entry upon the treestand platform, and should
be worn and attached to the tree at all times while using the treestand until safely back at ground level. Read and follow all instructions that were provided
with your FBFAHS.
The length of the harness tether shall be minimized at all times. It shall be adjusted so that it is above the head with no slack (or snug) in the seated
position. Failure to do so may result in suspension without the ability to recover to your treestand. Be aware of hazards associated with hanging suspended
in a FBFAHS and the fact that prolonged suspension in a harness may be fatal.
A signal device such as a mobile phone, radio, whistle, signal flare or personal locator device (PLD) must be on your person and available at all times. If
others are not aware of your hunting location and communication efforts are unsuccessful, you must have a personal plan for recovery/escape before you
ascend the tree - prolonged suspension in a harness can be fatal. It is important to exercise the legs by pushing against the tree or doing other forms of
continuous leg exercises to avoid blood pooling while being suspended. Hunters with varying degrees of physical fitness may require different plans to
recover/escape to avoid effects of prolonged suspension. Have a personal plan and practice it in the presence of a responsible adult before leaving the
ground. No escape/recovery plan will work for every hunter on every tree in every circumstance. Only you can determine the best recovery/escape plan
for your hunting situation and you must have a recovery/escape plan for your situation before leaving the ground. Hunt from ground when self-recovery/
escape ability is absent.
If there are any questions or concerns with instructions, warnings, or proper use, do not use the stand. Contact the manufacturer. Do not use unless you
fully understand safe and proper use. Maintain all warnings and instructions for later review as needed, for instruction usage to anyone borrowing your
stand/FBFAHS or to pass on when selling these items. Use all safety devices provided with your treestand and FBFAHS.
The use of a lineman's climbing belt as part of your FBFAHS is required when installing, using, or removing any climbing aid or fixed position treestand.
Inspect all ropes and/or straps and all stick ladder sections to ensure the sections are not separated prior to each use. Ensure the ground below the
climbing aid is firm and level.
Always place this product above a fixed position stand so that the user may step down into the stand.
Always step down into the foot platform area of any fixed position treestand. Placement of the fixed position treestand must be below the top end of the
climbing aid.
PRINTED IN CHINA
© 2021 Summit Treestands, LLC • PO Box 1295 • Birmingham, AL 35201
www.Summitstands.com
FAILURE TO READ AND FOLLOW ALL MANUFACTURER'S
WARNINGS AND INSTRUCTIONS CONSTITUTES A MISUSE OF THIS
PRODUCT AND COULD RESULT IN SERIOUS INJURY OR DEATH!
Summit 20' Steel Climbing Stick SU85302 - 1/2021

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SU85302 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Summit SU85302

  • Page 1 Summit 20’ Steel Climbing Stick Instructions SU85302 © 2021 Summit Treestands, LLC • PO Box 1295 • Birmingham, AL 35201 www.Summitstands.com WARNING FAILURE TO READ AND FOLLOW ALL MANUFACTURER’S WARNINGS AND INSTRUCTIONS CONSTITUTES A MISUSE OF THIS PRODUCT AND COULD RESULT IN SERIOUS INJURY OR DEATH! •...
  • Page 2 Never assume that any part, that may have been subjected to damage or wear, is ok for use. Stop use immediately and contact Summit Treestands immediately if you have any concerns or suspicions about your product.
  • Page 3 Weight Limits: (includes hunter’s weight PLUS weight of all gear carried into the treestand) DO NOT EXCEED THESE WEIGHT LIMITS! 300 lb Rated Climbing Aid: SU85302 - 20’ Steel Climbing Stick CLIMBING AID / COMPONENT WARNING LABELS (FOR REFERENCE ONLY) WARNING...
  • Page 4 www.Summitstands.com PG 4...
  • Page 5: Parts List

    PARTS LIST PART NUMBER DESCRIPTION IMAGE SU85302-01 Bottom Stick Section#1 SU85302-02 Stick Section #2 SU85302-03 Stick Section #3 SU85302-04 Stick Section #4 SU85302-05 Top Stick Section #5 SU85302-06 V-Bracket SU85302-07 Cam-Buckle Strap SU85302-08 Ratchet Strap PG 5...
  • Page 6 HARDWARE PACKET CONTENT (Each bag is numbered per corresponding assembly step and will also include washers and nuts necessary for each step) Step M6x35 Step M8x60 TOOLS REQUIRED (PROVIDED) 1 Allen Head Wrench (1 pcs) www.Summitstands.com PG 6...
  • Page 7 ASSEMBLY Section Assembly Hardware: 4pcs M6x35 Carriage Bolts 4 Steel Washers 4 Wing Nuts Each section of the climbing stick will be labeled with a number. The upper end of each section will be necked down to allow it to slide into the lower end of the section above it (except for Section #5 which has a step at the top and a closed end).
  • Page 8 V-Backet Assembly Hardware: 5pcs M8x60 Socket Cap Bolts 5 Knobs 5 Nuts Each step section except for the top section, Section #5, will have a circular bolt hole in between the top step of the section and the connection to the section above it. The top section, Section #5, will have a circular bolt hole in between its top 2 steps.
  • Page 9: Installation

    AT ALL TIMES when installing, removing or using any fixed position climbing aid or fixed position treestand. If you do SU85302-08 not have a FBFAHS (one should have been provided with your treestand) do not install or use this product.
  • Page 10 8. Have an able adult hold the Climbing Stick straight and against the tree. While they are holding the stick, use the Lineman’s Belt of your FBFAHS (per the instructions that were included with your FBFAHS) and Ratchet Strap Cam-Buckle Strap climb the bottom ladder section of the Climbing Aid Attachment Attachment...
  • Page 11 REMOVAL 1. With the climbing aid properly attached to the tree, attach WARNING your Lineman’s Belt to your FBFAHS following your FBFAHS instructions. Climb up the Climbing Stick sections until you When descending to remove the Climbing Aid: reach the top ratchet strap attachment point on Section #5. NEVER release any connecting straps until you Carefully loosen the ratchet strap until it is loose enough to are securely standing on the section below it and...
  • Page 12: Maintenance And Care

    It is expressly understood that Summit’s liability for its products, whether due to breach of warranty, negligence, strict liability, or otherwise, is limited to the repair of the product, as stated above, and Summit will not be liable for any other injury, loss, damage, or expense, whether direct or consequential, including but not limited to loss of use, income, profit, or damage to material, arising in connection with the sale, installation, use of, inability to use, or the repair or replacement of Summit’s products.
  • Page 13 Instructions relatives au bâton de montée Summit de 6 mètres (20 pi) SU85302 © 2021 Summit Treestands, LLC • PO Box 1295 • Birmingham, AL 35201 www.Summitstands.com LE FAIT DE NE PAS LIRE ET RESPECTER TOUS LESAVERTISSEMENTS AVERTISSEMENT ET TOUTES LES INSTRUCTIONS DU FABRICANT CONSTITUE UN MAUVAISE USAGE DE CE PRODUIT ET PEUT ENTRAÎNER DES BLESSURES GRAVES,...
  • Page 14 Inspectez toujours le produit en entier avant et après chaque utilisation! Ne partez jamais du principe que toute pièce qui peut avoir été endommagée ou usée convient à l’utilisation. Cessez immédiatement l’utilisation et communiquez avec Summit Treestands si vous avez des préoccupations ou des soupçons à...
  • Page 15 NE DÉPASSEZ PAS CES LIMITES DE POIDS! Aide à la montée d’une capacité de 136 kg (300 lb) : SU85302 - Bâtons de montée en acier Summit de 6 mètres (20 pi) ÉTIQUETTES D’AVERTISSEMENT DE L’AIDE À LA MONTÉE ET DES COMPOSANTS (À...
  • Page 16 www.Summitstands.com PG 16...
  • Page 17: Liste De Pièces

    LISTE DE PIÈCES NUMÉRO DE PIÈCE QTÉ DESCRIPTION IMAGE SU85302-01 Section de bâton inférieure no 1 SU85302-02 Section de bâton no 2 SU85302-03 Section de bâton no 3 SU85302-04 Section de bâton no 4 SU85302-05 Section de bâton supérieure no 5...
  • Page 18 CONTENU DES SACS DE QUINCAILLERIE (Chaque sac est numéroté en fonction de l’étape d’assemblage et contient également les rondelles et les écrous nécessaires pour chaque étape) Étape Qté M6x35 Étape Qté M8x60 OUTILS NÉCESSAIRES (FOURNIS) 1 clé hexagonale (1 mcx) PG 18...
  • Page 19 ASSEMBLAGE Assemblage des sections Quincaillerie : 4 boulons de carrosserie M6x35 4 rondelles d’acier 4 écrous à oreilles Une étiquette avec un numéro est apposée sur chaque section du bâton de montée. L’extrémité supérieure de chaque section est rétrécie afin de pouvoir la glisser dans l’extrémité...
  • Page 20 Assemblage du support en V Quincaillerie : 5 boulons à tête creuse M8x60 5 boutons 5 écrous Chaque section de marches, sauf la section supérieure no 5, est dotée d’un trou de boulon circulaire entre la marche supérieure de la section et le raccord avec la section du dessus.
  • Page 21 à la montée fixe ou Sangle à cliquet de tout mirador à position fixe. Si vous n’avez pas de SHCC SU85302-08 (on devrait vous en avoir remis un avec votre mirador), n’installez ou n’utilisez pas ce produit.
  • Page 22 8. Demandez à un adulte capable de retenir le bâton de montée droit et contre l’arbre. Pendant que cet adulte retient le bâton, utilisez la ceinture de monteur de votre SHCC (conformément aux instructions incluses avec votre SHCC) pour monter sur la section d’échelle inférieure de l’aide à...
  • Page 23 RETRAIT 1. L’aide à la montée bien attachée à l’arbre, attachez votre AVERTISSEMENT ceinture de monteur à votre SHCC conformément aux instructions du SHCC. Montez dans les sections de bâton de Quand vous descendez de l’aide à la montée pour la montée jusqu’au point d’attache de la sangle à...
  • Page 24: Entretien Et Soins

    Summit Treestands, LLC (Summit) garantit à l’acheteur original au détail que tous les produits qu’elle fabrique sont exempts de défaut de matériel et de fabrication au moment de l’expédition, et ce, pendant douze (12) mois à partir de la date d’achat. Summit réparera ou remplacera toute pièce défectueuse si l’unité...

Table of Contents