Active Aqua 2.0 Infinity Tray Installation Manual

2.0 INFINITY TRAYS
installation
Step 1.
Lay out the trays on the bench in the following order.
Start with the 1st End Tray w/ Drain. Create a 3/4" gap between
the front end of the tray and the front end edge of the bench.
*Division Tray placement is required between the last Middle Tray and End Tray.
Step 2.
Next evenly distribute the following trays with a 3-5 mm gap between the joints.
Step 3. On the last End Tray of the bench run create a 3/4" gap between the tail end of the tray and the tail end edge of the bench.
Step 4.
Before gluing, confirm you have spaced the trays correctly:
1
st
3/4"
gap
END TRAY W/ DRAIN
Active Aqua introduces the new and improved Infinity Tray series by Staal Plast
— an array of premium UV-stable High Impact Polystyrene (HIPS) expandable trays
that work with standard 4' and 5' wide benches. Designed for commercial
installations to maximize grow square footage.
A complete Infinity Tray setup MUST include:
1 qty - End Tray w/ Drain
1-7 qty - Middle Tray(s)
End Trays are 6.5' in length and available with Drain or without. Middle Trays
are 6.5' in length. Division Trays are available in 2' and 4' lengths.
Purely made from the highest quality HIPS, a reusable thermoplastic
material. After many years of continuous use, the trays are still
100% recyclable .
• Made in USA.
• Low profile 2.5-inch height .
• Stall Plast Polystyrene glue seals trays together at each joint
(STP3010 sold separately).
• No arch lip allows you to maximize your inner tray space.
• Maximum tray length 65'. Up to 7 qty Middle Trays.
• Division Trays can be cut to size (top of block only).
1st - End Tray w/ Drain (1 qty)
2nd -
Middle Trays (up to 7)
a. 3/4" space at the front and tail end of the bench run.
b.
3-5 mm space between all tray connections.
2 3
nd
MIDDLE TRAY DIVISION TRAY
1 qty - Division Tray
1 qty - End Tray
3rd -
Division Tray (1 qty)
4th - End Tray (1 qty)
4
rd th
END TRAY
3/4"
gap