Advertisement
Quick Links
Operation Manual
Mobile Gas Heater
65067
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Summary of Contents for WilTec 65067
- Page 1 Operation Manual Mobile Gas Heater 65067 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Always use the prescribed or standard cables, plugs, and sockets. Always protect them from moisture or water. • The heater must not be located directly below an outlet. © by WilTec Wildanger Technik GmbH Item 65067 Page 3 http://www.wiltec.de 05 2024-1...
- Page 4 The pilot flame and the main burner should remain lit. You can now set the heating level to Low/Medium/High as needed. © by WilTec Wildanger Technik GmbH Item 65067 Page 4 http://www.wiltec.de...
-
Page 5: Installation
Do not attempt to locate the leak with an open flame. Locate the leak by sound, smell, or by applying soapy water. If bubbles form, it is an indication of a leak. © by WilTec Wildanger Technik GmbH Item 65067 Page 5 http://www.wiltec.de... - Page 6 Do not attempt to remove the regulator while the heater is still in operation. • Replace the liquid gas bottle in a well-ventilated area and away from any ignition sources (can- dles, cigarettes, etc.). © by WilTec Wildanger Technik GmbH Item 65067 Page 6 http://www.wiltec.de...
- Page 7 If parts need to be replaced, they must only be replaced with original parts. Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. © by WilTec Wildanger Technik GmbH Item 65067 Page 7 http://www.wiltec.de...
Need help?
Do you have a question about the 65067 and is the answer not in the manual?
Questions and answers