Subscribe to Our Youtube Channel
Related Manuals for Dakota Digital GRAFIX Series
Summary of Contents for Dakota Digital GRAFIX Series
- Page 1 CAM-2000 Flush Mount Backup Camera Your new CAM-2000 includes: Camera Assembly (x1) PWR In / Video Output Cable (x1) Wing Mount Bagged items (x1) Hole saw (x1) Video Extension Cable (x1) MAN #650822...
- Page 2 Setup of the GRAFIX system to use the CAM-2000 is simple and straightforward, and as seen in the diagram(s) below the wiring is as well - which you have come to expect from Dakota Digital. Using this guide, you will be able to select the wiring method that best suits your application.
- Page 3 Basic Wiring Block Diagram Before getting started with the installation of the CAM-2000 in the vehicle, the user must select a mounting location and understand the wiring requirements. Questions to ask could include: • Where and how will the camera be mounted? •...
- Page 4 EX+: Use this menu selection when connecting the EX+ terminal of the Control Box to the vehicle’s backup lights or reverse switch. If using a Dakota Digital GSS gear position sensor, the GSS BACKUP terminal can be connected to the EX+ terminal of the GRAFIX control box.
- Page 5 Camera Mounting The CAM-2000 can be mounted several ways on the vehicle. Here are a few examples: Surface Mount on the bumper, trunk lid or other vertical surface Note: The CAM-2000 does not have user adjustments for left/right alignment, so locating the camera as close as possible in the center of the vehicle will provide the best results Note: Be sure there is adequate clearance for the camera and the wire harness on the backside of the surface being drilled.
- Page 6 Position the camera assembly above the license plate or other horizontal location – Image (6) below Using the adhesive tape attached to the wing bracket, secure the camera to the underside of the deck lid or other horizontal surface Note: When securing the camera on the wing bracket with the ‘flat-edge’ bezel, pay attention to the arrow on the camera label –...
- Page 7 Troubleshooting guide Problem Possible cause Solution GRFX Display Panel does not GRAFIX camera trigger not configured Go in to the GRAFIX SETUP menu and set the display camera video or have Reverse detection sensor is not functioning or proper trigger according to the wiring a blue raster is wired incorrectly Confirm wiring is correct and trigger is present...
- Page 8 This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.
Need help?
Do you have a question about the GRAFIX Series and is the answer not in the manual?
Questions and answers