Tria MAAXBOARD OSM93 Quick Start Manual

A. Procedure for Out-of-Box Operation
1. With the board disconnected from 5V power, ensure DIP SW1.1 is OFF, for boot from EMMC flash:
SW1.1 EMMC
SW1.2 LP BOOT / SINGLE BOOT
SW1.3 USER ON / OFF
2. Connect a USB-to-serial cable (any inexpensive aftermarket USB Serial cable can be used) from the
debug header A55 (lower-row) pins, to a USB port on the development computer
3. Open a serial console (eg. Tera Term), select the COM port# for this cable and apply these settings:
• Baud rate: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
4. Connect an Ethernet cable from ETH_A (J5) or ETH_B (J2) to your network router (board should be on
same sub-LAN as the development computer)
5. Connect a 5V 2A power source to MaaXBoard OSM93 DC 5V power-input USB-C connecter (J11),
to power-up and boot the board (there is no need to press the PWR button).
6. The RGB LED will illuminate RED and uboot and Linux boot log messages will display on the serial
console while the board boots-up.
7. Enter root to login, when the Linux login prompt appears in the console window.
8. Enter uname -a at commandline prompt to check the installed Linux OS version, then check the product
page website to see if this the latest version of the Linux BSP. Links to latest prebuilt images are located
under "Reference Designs" tab, in the "Technical Documents" area of
product page. If the reported kernel version is earlier than these latest image files, then consider
upgrading to the latest version, using the re-flashing procedure on the next page.
9. Make sure to re-visit frequently this
reference designs, links to FAQs, blogs and training material.
15-Dec-24
Console
Interface
/ USB DL OFF
OFF
OFF
avnet.me/maaxboard-osm93
MAAXBOARD OSM93 Quick-Start Guide v1.0
MAAXBOARD
Quick-Start Guide
avnet.me/maaxboard-osm93
for latest technical documents,
OSM93
DIP switches
Page 1 of 3