Sam 1634L Manual

1634L
3" CUT-OFF TOOL-
LONG NECK
Tool Specification:
Free Speed:
Cutting Wheel Size:
Disc Hole Size:
Air Inlet:
Hose Size:
Air Pressure:
Horsepower:
SAFETY RULES
READ, UNDERSTAND AND KEEP THESE INSTRUCTIONS,
WARNING Failure to follow all instructions listed below may result in serious injury.
WORK AREA HAZARD & PERSONAL SAFETY
1. Keep your work area clean and well lit.
2. Do not operate power tools in explosive atmospheres, such as in the presence of
combustible liquid, gases or dust. Power tools create sparks which may ignite the dust or
fumes.
3. Disconnect tool before performing service or when not in use.
4. High sound levels can cause permanent hearing loss. Use hearing protection during
operation.
5. Maintain a balanced body position and secure footing.
6. Slips/Trips/Falls are a major cause of serious injury or death. Be aware of excess hose left
on the work floor.
7. Repetitive work motions, awkward positions and exposure to vibration can be harmful to
hands and arms. If numbness, tingling, pain or whitening of the skin occurs, stop using the
tool and consult a physician.
8. Always wear impact-resistant eye and face protection when operating, repairing or
performing maintenance of the tool or while changing tool accessories.
TOOL USE AND CARE
1. Use support handle or other method to secure and support the work piece to a stable
platform.
2. Do not force the tool. Use the correct tool for your application. Using the correct tool which
is specifically designed for a select job will provide better tool performance and make the
job easier.
17,000 RPM
3" (75 mm)
3/8" (10mm)
1/4"
3/8" (10 mm) I.D.
90 P.S.I. (6.2 Bar)
0.7HP (0.52Kw)