DiodeDrive DVMM-xW-24V-5JF User Manual

Important: Read all instructions prior to installation.
5-in-1 Dimmable LED Driver
Specifications
Environmental Specifications
Operating Temperature
NEMA Rating
Environmental Rating
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Output Voltage Adjust
Outpu t Vol t Adjustment
Fine Tuning
the Output Voltage
See below:
12V Ouput: 9V-13V
24V Output: 17V-25V
48V Output: 36V-49V
(Output varies by model)
Installation
1. Install the driver firmly onto the lamp bracket with suitable screws.
2. Make all wiring connections and briefly apply power to test for proper function.
Once proper operation is confirmed, remove power again and complete installation.
3. Ensure heat dissipation is appropriately addressed within the fixture and that all wiring connections are airtight and waterproof.
Only after these requirements are sufficiently met can the driver be operated.
4. If any event occurs, such as tripping or irregular operation, disconnect the power main and the connection to the luminaire before
investigating the problem. If the driver is found to be defective, please get in touch with customer support for resolution.
-40°–140° F (-40°–60° C)
4X
Suitable for wet locations
Safety and Notes
• Product should be installed and serviced by a certified electrician
in accordance with applicable national, state, and local building and
electrical codes.
• To reduce the risk of electric shock, ensure that the main power source
and circuit breakers are switched off before performing any installation
or wiring procedures.
• Ensure all mounts are securely attached and will support the weight of
the power supply. Failure to properly support may result in damage or
injury, for which the manufacturer does not assume responsibility.
• Installation of over-voltage protection and surge protection devices in
the power supply circuit of lamps is recommended to ensure safety
during use.
• When adjusting the output current of the power supply, please ensure
that the total output power does not exceed the rated Max. power as
this will void the warranty.
• Do not install in completely sealed enclosures. Enclosures must be
ventilated with holes to allow air passage.
• Driver must be mounted with a 5" gap of free-flow air space for proper
ventilation. Never mount above heat radiated objects.
• Suitable for wet locations. Do not expose to corrosive gas or liquids.
• Ensure the installation of the power supply complies with all
driver specifications.
9 0 1
8 2
7 3
4
6 5
Rev Date: V1 08/02/2024
4400 Earth City Expy, St. Louis, MO 63045
User Manual
DVMM-xW-24V-5JF
250Hz-20KHz
Switch to different gears
to choose frequency
See below:
0: 4000Hz 5: 2000Hz
1: 250Hz 6: 3600Hz
2: 400Hz 7: 8000Hz
3: 800Hz 8: 16000Hz
4: 1470Hz 9: 20000Hz
866-201-2238 diodedrive.com