Advertisement
Quick Links
UNCRATNG AND INSPECTION
ASSEMBLY AND INSTALLATION
ELECTRICAL INSTALLATION
HEATER TUBE INSTALLATION
OPERATING PROCEDURE
CLEANING (DAILY & WEEKLY)
GENERAL MAINTENANCE
SPARE PARTS LISTINGS
ORIGINAL EQUIPMENT WARRANTY
OM-017
Foodservice Equipment Specialists
P.O. Box 880 Saco, ME. / U.S.A. 04072
877-854-8006 * FAX (207) 283-8080
OPERATIONS AND MAINTENANCE PROCEDURES
CHEESE MELTER – JW30, JW30PA
FOR SERVICE ASSISTANCE
U.S. AND CANADA CALL: 1-877-854-8006
24 HOURS/DAY 7 DAYS/WEEK
TABLE OF CONTENTS
PAGE 1
PAGE 1
PAGE 2
PAGE 2
PAGE 3
PAGE 3
PAGE 4, 5
PAGE 5
PAGE 6
03/03/2014 MJC
Advertisement
Summary of Contents for Belleco JW30
- Page 1 Foodservice Equipment Specialists P.O. Box 880 Saco, ME. / U.S.A. 04072 877-854-8006 * FAX (207) 283-8080 OPERATIONS AND MAINTENANCE PROCEDURES CHEESE MELTER – JW30, JW30PA FOR SERVICE ASSISTANCE U.S. AND CANADA CALL: 1-877-854-8006 24 HOURS/DAY 7 DAYS/WEEK TABLE OF CONTENTS...
- Page 2 Page 1 OPERATIONS AND MAINTENANCE PROCEDURES CHEESE MELTER – JW30, JW30PA UNCRATING AND INSPECTION Unpack the unit and components from the shipping container. Remove all visible packing materials. If damage is discovered, file a claim immediately with the carrier that handled the shipment.
- Page 3 Improper grounding may result in serious personal injury or could be fatal! ELEMENT INSTALLATION Models JW30 and JW30PA use quartz sheathed heater elements which are held in position by spring loaded Sockets. BEFORE REMOVING PANELS OR ELEMENTS DISCONNECT UNIT FROM POWER...
- Page 4 PAGE 3 OPERATIONS AND MAINTENANCE PROCEDURES CHEESE MELTER – JW30, JW30PA OPERATING PROCEDURE JW30 Switch unit to the “ON” position - Only the front and rear elements will turn on placing • unit in standby mode. Set Timer to allow 10 – 15 minutes to heat from cold.
- Page 5 Heater Tube from socket on right. 3. Carefully guide Heater Tube out of unit. 4. Install new Heater Tube by placing tube end into left Socket. While pushing end into UPPER ELEMNTS : MODEL JW30 / W30PA spring HEATER TUBE SOCKETS: METAL CONTACTS IN SOCKET...
- Page 6 7. Replace panels and test under power. "If the power cord for fan motor is damaged, it must be replaced by a special cord or assembly available from the manufacturer (Belleco, Inc.) or its service agent" JW30 / JW30PA SPARE PARTS LISTS...
- Page 7 BELLECO, Inc. is deemed to be defective. This warranty shall be effective for a period of twenty-four (24) months for parts (excluding heater elements s) and twelve (12) months for...
Need help?
Do you have a question about the JW30 and is the answer not in the manual?
Questions and answers