Summary of Contents for Scooter Xtras BREAKDOWN BUDDY
- Page 1 SCOOTER XTRAS MOBILITY SCOOTER / POWERCHAIR ACCESSORIES BREAKDOWN BUDDY SXPUMP Edition 1 USER MANUAL Please read and keep these instructions scooterxtras.com ASK FOR THE BRAND...
- Page 2 SCOOTER XTRAS is part of FOR-DE Group V Ltd INTRODUCTION Thank you for purchasing this SCOOTER XTRAS product. If you have any issues or questions about the Breakdown Buddy please contact your supplier or SCOOTER XTRAS direct: T: +61 8 9248 4180 E: orders@for-de.com.au...
- Page 3 CONTENTS UNPACK and INSPECT SUPPLIED PARTS PRODUCT OVERVIEW CABLE CHARGING FLEXIBLE HOSE / NOZZLE INFLATION SETTINGS TORCH / HAZARD LIGHTS INSPECTIONS / CLEANING SAFETY ADVICE WARRANTY NOTES UNPACK and INSPECT SUPPLIED PARTS Ensure you have been supplied with the following parts: 1 x Fine 1 x Portable Air Nozzle...
- Page 4 - Battery No Load Discharge Time: >15 min - Unit Conversion: 1 BAR / 14.5 PSI / 0.1 MPA / 101 KPA - Product Weight: 0.5kg Please contact SCOOTER XTRAS if you would like any further information on the product. IMPORTANT NOTE:...
- Page 5 CABLE CHARGING Please charge the Breakdown Buddy before using. The product comes with a USB-A and USB-C charger cord that can be used to charge the device through a suitable USB device. The product also acts as a power pack that is capable of charging any mobile device with a USB-A and USB-C charger port.
- Page 6 FLEXIBLE HOSE / NOZZLE After power is turned on, connect the flexible hose to the insert located at the top of the product and tighten it. This will secure the hose in place and make sure the hose is sealed tight otherwise the product may not operate to the desired effect.
- Page 7 INFLATION SETTINGS Please follow these instructions to properly operate the device’s inflation settings. Press the power button for 2 seconds to turn on device. The compressor will go into hibernation mode after 2 minutes of non-use / standby. The inflation settings can be preset to the required value of the product that is being inflated and will automatically stop inflating once the product reached the preset value.
- Page 8 Press the light button to switch between the torch and the hazard light settings. INSPECTIONS Visually and physically look over the Breakdown Buddy for signs of damage or wear prior and during use. Inspect the entire product and pay close attention to the...
- Page 9 For your own safety please read the user manual to get the optimal benefit from the Breakdown Buddy. Failure to follow these guidelines may result in damage to the product and put the user at risk. If any doubt, contact your supplier directly for advice.
- Page 10 Note: Warranty is not transferable. Scooter Xtras will repair or replace, at our option free of charge any part found on examination by Scooter Xtras to be defective in material and or workmanship within the warranty period.
- Page 11 NOTES scooterxtras.com ASK FOR THE BRAND...
- Page 12 DISTRIBUTOR: SCOOTER XTRAS MOBILITY SCOOTER / POWERCHAIR ACCESSORIES Proudly Australian Owned and Operated scooterxtras.com ASK FOR THE BRAND redgumbrand.com.au...
Need help?
Do you have a question about the BREAKDOWN BUDDY and is the answer not in the manual?
Questions and answers