Page 1
Quick release connector PRESSURE PRE-SET deflation valve 12v programmable tyre INFLATOR USER GUIDE 27010UG 10/23...
Page 2
Thank you for purchasing the MICHELIN 12v programmable tyre inflator Please read these operating instructions carefully before using the inflator. Improper use can cause damage to property and possibly harm the user. When using the inflator to inflate tyres ensure the vehicle is parked in a safe location, off...
Page 3
MICHELIN 12v programmable tyre inflator OPERATING FEATURES Inflation start/stop Mode selection button White LCD digital display Selection buttons/worklight on/off COB worklight 40 cm (approx.) high pressure air Deflation button hose with quick release valve connector Input for 300 cm (approx.) detachable...
Page 4
(hissing) from the valve. If a hiss occurs, remove the connector by holding the grey collar and pulling it back and try again. ADAPTeRS Included with your MICHELIN 12v Programmable Tyre Inflator are 3 adapters, to enable you to inflate other items. To avoid overinflation, always follow the manufacturer’s instructions on the items to be inflated.
Page 5
Small Toy Adapter Small inflatable toys use the small toy inflator adapter. To connect the adapter to the quick release valve connector push and hold the adapter into the hole of the connector with one hand while holding the quick release connector at its base (Fig 1) push the connector forward.
Page 6
Motorcycle mode: default pressure (flashing) is 34 psi. Adjustable range: 14-51 psi. Bicycle mode: default pressure (flashing) is 45 psi. Adjustable range: 15-100 psi. Ball mode: default pressure (flashing) is 8 psi. Adjustable range: 2-16 psi. Free mode: default pressure (flashing) is 0 can be adjusted freely under free mode. Adjustable range: 3-100 psi.
Page 7
To set a target pressure The default pressure is PSI. To change to BAR or kPA press the mode button M (5) twice (pressure format icon will flash) while flashing press the button to scroll between the pressure formats. Once the selected format stops flashing the new selection is set.
Page 8
CONVERSION CHART 0.69 1.38 2.07 2.76 3.45 4.14 4.83 5.52 6.21 6.89 Remove the 12v plug and leave the unit off for 5 The display shows garbled characters minutes. If the display is still unreadable when the 12v plug is connected again contact the helpline number below.
Need help?
Do you have a question about the 27010 and is the answer not in the manual?
Questions and answers