Advertisement
Quick Links
Advertisement
Related Manuals for Worx WG898 Series
Summary of Contents for Worx WG898 Series
- Page 1 20V 7 in. Cordless Brushless Edger WG898 WG898.X...
- Page 3 100%...
- Page 6 TABLE OF CONTENT 7) Don’t grasp the exposed cutting blades or cutting edges when picking up or holding the product. 8) Don’t Force Product - It will do the job better and 1. PRODUCT SAFETY with less likelihood of a risk of injury at the rate 2.
- Page 7 This will ensure that the safety of the product is n) Recharge only with the charger specified maintained. by Worx. Do not use any charger other than 11. Do not modify or attempt to repair the product that specifically provided for use with the or the battery pack (as applicable) exc equipment.
- Page 8 3.TECHNICAL DATA Do not burn WG898 WG898.X** Batteries may enter water cycle if Maximum output disposed improperly, which can 320 W power be hazardous for ecosystem. Do Rated No-load speed 4000/min not dispose of waste batteries as unsorted municipal waste. 1.5”...
- Page 9 must edge under conditions that cause the blade Adjusting cut depth See Fig. C chamber to become clogged, release trigger, wait for blade to come to complete stop! REMOVE Raising/lowering Edge Guide See Fig. D BATTERY! And remove clogged material with a OPERATION stick.
- Page 10 5.MAINTENANCE Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers or other qualified service organizations.
- Page 11 Copyright © 2023, Positec. All Rights Reserved. Copyright © 2023, Positec. Tous droits réservés. © Derechos reservados 2023, Positec. Todos los derechos reservados.
Need help?
Do you have a question about the WG898 Series and is the answer not in the manual?
Questions and answers
When the on/off trigger is activated, the edger runs but only runs for about 15 seconds and then cuts off. It will immediately restart but again will cut off after several seconds. How do I get it to continue to run?