AOS S Series Quick Start Manual

Quick Start Guide Quick Start Guide Quick Start Guide Quick Start Guide
AOS S S S S - - - - Q Q Q Q - - - - and TRI AOS AOS AOS and TRI and TRI and TRI- - - - SERIES SERIES SERIES cameras SERIES cameras cameras cameras
What You Need to Get Started What You Need to Get Started What You Need to Get Started What You Need to Get Started
To use an S/Q/TRI-SERIES camera, you need:
A Windows PC with min
100 BASE-T Ethernet (1000
BASE-T recommended)
interface
CAT 5e Ethernet cable (CAT 6
recommended)
Power/Trigger Adapter
Power supply
AOS Imaging Studio software
Installing the Software Installing the Software
Installing the Software Installing the Software
Administrator Privileges are required for
Note:
proper installation of the software! Switch off any
Anti-Virus software running on your PC!
Insert the CD and run the setup („AOS Imaging
Studio setup.exe").
Follow the instructions on the screen until the
installation is finished.
Setting up the Network Connection Setting up the Network Connection Setting up the Network Connection Setting up the Network Connection
Deactivate the internal firewall of
the PC, open ports for:
Camera: Camera: Camera: Camera:
Ports 2100 and 2101 open
Imaging Studio: Imaging Studio: Imaging Studio: Imaging Studio:
Ports 15'000 – 15'200 open
The firewall of Windows can be
configured in Start Start ⇒ Run... Run... ⇒ enter "firewall.cpl
Start Start Run... Run...
The camera camera's default network address is:
camera camera
IP address: 10.0.0.115
Subnet mask: 255.255.255.0
Select Start Start Start Start ⇒ Run... Run... ⇒ enter Run... Run...
"ncpa.cpl ncpa.cpl ncpa.cpl ncpa.cpl" and double-click the
Ethernet connection used for the
camera. Choose Properties Properties and Properties Properties
scroll down to Internet Protocol Internet Protocol Internet Protocol Internet Protocol
Version 4 (TCP/IP Version 4 (TCP/IPv4 v4 v4 v4) ) ) ) . Choose it
Version 4 Version 4 (TCP/IP (TCP/IP
and click Properties Properties.
Properties Properties
Select Use the following IP Use the following IP Use the following IP Use the following IP
address address address and change the network address
address of your PC PC PC PC to:
IP address: 10.0.0.100
Subnet mask: 255.255.255.0
Connecting the Camera Connecting the Camera Connecting the Camera Connecting the Camera
Switch on the camera and
wait until the green System
LED is constantly on (15 - 20
sec).
When the System LED is on, you can connect the
camera to the PC and start Imaging Studio.
firewall.cpl"
firewall.cpl firewall.cpl
Imaging Studio should
recognise the camera and
show "LIVE" mode.
For additional information please also refer to the
user's manual. The manual can be found on the
enclosed CD (AOS Imaging Studio) or
downloaded from the AOS Technologies home
page (www.aostechnologies.com/downloads).
Now continue with
Guide
(on reverse).
Imaging Studio Quick Start