Advertisement
Quick Links
Advertisement
Summary of Contents for Worx WG869
- Page 1 20V Cordless Spreader 20V Cordless Spreader 20V Cordless Spreader WG869 WG869.X...
- Page 3 100%...
- Page 5 TABLE OF CONTENT the risk of injury. Follow instructions for lubricating and changing accessories. Keep handles dry, clean, and free from oil and grease. 1. PRODUCT SAFETY 14) Check Damaged Parts - Before further use of the 2. COMPONENT LIST product, a guard or other part that is damaged should be carefully checked to determine that it will 3.
- Page 6 Recharge only with the charger specified by 7. After the snow stops in winter, when spreading Worx. Do not use any charger other than that snowmelt on sidewalks, driveways or in front of retail specifically provided for use with the equipment.
- Page 7 SYMBOLS To reduce the risk of injury, user must read instruction manual WARNING Do not burn Batteries may enter water cycle if disposed improperly, which can be hazardous for ecosystem. Do not dispose of waste batteries as unsorted municipal waste. Li-Ion battery, battery must be recycled POSITEC Inc.
- Page 8 5.ASSEMBLY & OPERATION are included in standard delivery. Action Figure 3. TECHNICAL DATA BEFORE OPERATION Type WG869 WG869.X (3 - designation of ma- Installing/Removing the Battery See Fig. A chinery, represenTative of battery operated chain Pack saw) Checking the battery charge WG869 WG869.X **...
- Page 9 °F (0 °C-40 °C). Adjust spreading width Set the spreading width by using the speed-control dial and the edge-control deflector. NOTE: When the material See Fig. E1, E2 diameter exceeds 4mm, it is advisable to adjust the spreading speed to a lower setting to prevent material crushing.
Need help?
Do you have a question about the WG869 and is the answer not in the manual?
Questions and answers