BATO B-WL65303 SMD User Manual

User Manual B-WL65303 SMD
Before your first use, do please charge and
discharge the batteries
Safety precautions
Do not use the lamp in the immediate vicinity of
•
inflammable materials or gases.
• Make sure that the illuminants are not covered
during use.
Only use the accessories included with the
•
product for recharging your rechargeable
workshop lamp.
• Keep the lamp out of reach of unauthorised
persons, especially children.
• Do not point the light directly in your own or any
other person's or animal's eyes.
Always check the mains cable before you use the
•
charger. If the mains cable is damaged, replace
the charger.
Do not dispose of used batteries with domestic
•
waste, but leave them at an appropriate
collection point for disposal.
The plastic in this product may contain chemicals
•
known by the state of California to cause cancer
and birth defects or other
reproductive harm. Wash hands after handling.
Lamp design and accessories
400 lumen front main white SMD LED
•
Secondary rear 200 lumen white SMD LED
Extra top torch – 120 lumen white SMD LED
Ultra tough nylon, aluminium construction
•
200° vertical folding head with super strong
•
magnetic Base
Buckle & Hanging system easy for use
•
Two strong magnetic at the back side of lamp
•
• IK07 super tough shock resistant construction
Large reflector SMD LED
•
5V charging system for recharging the batteries
•
Built-in USB-C charging port with protective
•
cover
1A direct USB-C charging - 2 hours charge time
•
1m USB-C charging cable included
•
Safety design :
•
Charging and discharging protection
High efficiency & Low power consumption
Technical data
3.7V – rechargeable battery, Lithium 800mAh
•
LED : Front Main 3W SMD LED
•
Rear 1.5W SMD LED
Top Torch :1W SMD LED
Luminance: Approx 400Lm Front Main
•
Approx 200Lm Rear LED
Approx 120Lm Top Torch
• Ambient temperature: -10° - +45°C
• Usage period: 3h to 6h for Main Front LED
6h for rear LED
6h for Top Torch LED
Dimming switch for Main front LED : 100%-50%
•
• Charging period: approx. 2h
• Protection class: III
• Charging input: 5V 1000mA
Recharging
Completely charge the batteries before your first
•
use the lamp.
The lamp must be charged per three months to
•
protect the battery lifetime.
Charging using an 5V DC USB charger
Plug the power supply into USB main charger
•
Plug the charger cable into the USB-C socket .
•
• The red LED will light up during the charge.
Once the batteries are completely charged, the
LED turns green
Usage
The on-off switch
Press 1 : Top Torch ON
• st
Press 2 : Front Main 50% ON
• nd
Press 3 : Front Main 100% ON
• rd
• Press 4 th : Rear LED 100% ON
• Press 5 th : Front + Rear LED ON
Press 6 th : OFF
•
Noted :
If left in any mode for over 5 seconds , the next
press will turn the light OFF .