Salsbury Industries 83000 Series Installation Instructions

15" Wide Vented Lockers – 83000 Series
Thank you for selecting Salsbury's 15" wide vented triple tier lockers. These instructions are intended to assist you in assembling the lockers. Assembly of the various locker
components will be with #10 - 24 x 3/8" long slot less screws and #10 nuts (provided). Loosely fasten a screw and a nut into every set of mating holes with the screw heads positioned on
the outside of the locker or on the exposed surface.
One Wide Locker Assembly
Step 1: Attach the top shelf, bottom shelf, and three coat hooks to the back panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and two compartment dividers to the assembly from
Step 1. Attach an additional three coat hooks to the first side panel.
Phone: 1-800-562-5377
Fax: 1-800-562-5399
www.lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Triple Tier Installation Instructions
SALSBURY INDUST R IES
18300 Central Avenue, Carson, CA 90746-4008
Copyright © 2020 Salsbury Industries. All rights reserved. Page 1 of 5 3/27/14
Step 3: Attach the second side panel and the right rear leg to the assembly of Step 2.
Attach an additional three coat hooks to the second side panel. The locker chassis is
now complete.
Step 4: Attach the pre-assembled door frame onto the assembly of Step 3.
Step 5: Tighten all fasteners checking for squareness of the locker while tightening.
Attach optional sloping hood, end bases or front base (see pages 4 and 5).
Step 6: Place the locker in the installed location and anchor to the floor, wall, or to
both. Individual job conditions will dictate the type of fastening anchors to use (not
provided).
Step 7: Fasten all lockers in a row together by installing fasteners provided through
the side panels. Installation is now complete.
Int'l Phone: 323-846-6700
Int'l Fax: 323-846-6800
engineering@lockers.com