Garmin TACX CYCLING DISPLAY Installation Manual

GARMIN
TACX CYCLING DISPLAY
P11599 21/07/2020
INSTALLATION GUIDE
Tools Required - Supplied
13MM SPANNER 2.5MM ALLEN KEY
1
WHEEL BASE SECTION
INTO POSITION
4
GARMIN Confidential for internal use only. | Page 1
Parts
B x1
A x1
2
OPEN DOOR WITH KEY PROVIDED
A x1 SO THAT ACCESS CAN BE GAINED
INSIDE OF UNIT DURING
ASSEMBLY
5
NEXT REMOVE SHELVES
SO THAT BETTER ACCESS
CAN BE MADE DURING
ASSEMBLY
LIFT 2 OFF SHELVES AND
TILT SHELVES OUT.
PLACE TOP SECTION FACE DOWN
ON CARDBOARD BOX AND
THREAD ON M8 NUTS ONTO 6 OFF
THREADS.
USE 13MM SPANNER
C x1 D Cradle set
4x E2 1x D1
IT IS IMPORTANT THAT LARGE GAP IS
LEFT BETWEEN NUT AND METAL
FRAME BEFORE THE NEXT STAGE TO
ENSURE EASY LOCATION ON
KEYHOLE CUTOUTS ON BASE
B x1
CABLE KIT
1 OFF 3m IEC TO UK PLUG
1 OFF 3m IEC TO EURO PLUG
1 OFF 3m IEC TO SWISS PLUG
1 OFF 5m IEC TO EURO PLUG
(FOR POWERING TACX TRAINER)
1x D2 1x I1
1 OFF IEC TO FIGURE 8 CABLE CONVERTER
(FOR POWERING TACX TRAINER)
3 OFF 1m FLOORING CABLE COVERS
3
1.
MAKE SURE BOTH
BRAKES ARE ENGAGED
AND POSITIONED
OUTWARD
NEXT APPLY BOTH REAR BRAKES
ACCESSING BRAKE LEVERS THROUGH ROUND
CUTAWAYS
MOVE UNIT SIDE TO SIDE SLIGHTLY UNTIL LEVERS
ARE VISIBLE AND THEN ENGAGE ONE AND THEN
SLIGHTLY MOVE THE UNIT IN THE OPPOSITE
DIRECTION TO MOVE OTHER BRAKE LEVER INTO
VISIBLE POSITION AND ENGAGE IT.
6
LIFT TOP SECTION ONTO KEYHOLE SLOTS
ON BASE SECTION. MAKE SURE NUT
PASSES THROUGH THE KEYHOLE SLOT.
THEN SLOWLY DROP THE STUDS DOWN
INTO THE SMALLER SECTION OF THE
KEYHOLE TO LOCK IN PLACE.
MUST BE LIFTED BY 2
PEOPLE AND NUTS MUST PASS
THROUGH SLOT AND MAKE
SURE TO FEED
3 OFF POWER CABLES IN
THROUGH FRONT OPENING
FIXINGS
12 OFF M8
LOCKING
NUTS
2.