Pioneer CLD-D99 Operating Instructions Manual

The Art of Entertainment
CD CDV LD PLAYER
REPRODUCTOR DE CD, CDV YLD
CD, CDV, LD sastaeeci
This player is not suitable for commercial use.
@VIDEO CD, LD-ROM, CD-ROM and CD graphic discs cannot ip
played with this player.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will know
how to operate your model properly. After you have finished
reading the instructions, put them away in a safe place for future
reference.
In some countries or regions, the shape of the power plug and
power outlet may sometimes differ from that shown in the
explanatory drawings. However, the method of connecting and
operating the unit is the same.
WARNING :: To prevent FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card
and keep it in a secure area. This is for your security.
THE POWER SWITCH 1S SECONDARY CONNECTED AND
THEREFORE DOES NOT SEPARATE THE UNIT FROM MAINS
POWER IN STANDBY POSITION.
Operating Instructions
Manual de instrucciones
RM AB
English
Espaiiol
aaa
§ acadiier
ReBESirE AP BPS .
DIGITAL AUBIO LASER DISC
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch. U.S.,
Canadian, European, U.K., and Australian models are not provided
with this switch.
The line voltage selector switch is located on the rear panel of this
player. Before your player is shipped from the factory, the switch
is set to the power requirements of the player's destination. Check
that it is set properly before plugging the power cord into the
outlet. if the voltage is not properly set or if you move to an area
where the voltage requirements differ, adjust the selector switch
as follows:
Use a medium-size (flat blade) screwdriver. Insert the tip of the
screwdriver into the groove of the selector switch and turn it to set
the player to the power voltage of your area.
WOUTAGE
SELECTOR
Set the voltage selector so that the
arrow points to the power voltage of
your area. (Figure shows arrow
pointing to 220 - 240 volts.)