Homewerks GR001SS Instruction Manual

GLASS RINSER
GR001SS - Stainless steel finish
GR001MB - Matte black finish
PACKAGE AND HARDWARE CONTENTS
PART DESCRIPTION
A
B Center Post with Rubber O-Ring
C Rubber Washer
D Metal Washer
E Mounting Nut
F Actuator
G Extender Tee
H Rubber Gasket
I Glass Rinser Connector
J Optional Flat Spacer
K Optional Angled Spacer
Due to constant design and quality improvements, the product may look
slightly different from the picture.
SAFETY INFORMATION
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
PREPARATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package and hardware contents list. If any part is
missing or damaged, do not attempt to assemble the product. Contact
customer service for replacement parts.
IMPORTANT: Before beginning installation, make sure the glass rinser
will fit the sink.
• The minimum hole diameter in the countertop/sink required for
installation of the glass rinser is 7/8 in.
• The maximum distance from the middle of the center post hole to the
edge of the sink basin is 3 in. to ensure proper drainage into the sink
basin.
• The minimum distance required from the middle of the center post hole
to the back of the glass rinser is 2-1/4 in.
Need Help? Please call our toll-free line at (877) 319-3757 (7:30 am to 4:30 pm CST) for additional assistance or service.
Homewerks Worldwide, LLC • Lake Bluff, IL 60044 • Homewerks.com
QUANTITY
Base 1
1
1
F
1
1
1
1
1
1
A
1 J
1
K
CAUTION
• Cover the sink drain to avoid losing parts.
Estimated Assembly Time: 30 minutes
Tools required for assembly (not included): adjustable wrenches, slip joint
pliers, pipe wrench, and silicone.
Installation may vary depending on how the previous accessory was
installed. Supplies necessary for the installation of the accessory are not all
included; however, they are available wherever plumbing supplies are sold.
When installing the glass rinser, hand tighten the connector nuts. DO
NOT OVERTIGHTEN. Connections that are too tight will reduce the
integrity of the system.
B
C
D
E
I
G
H
05/2023