Advertisement
Quick Links
Ph: 02 9896 1165 Fax; 02 9896 4465 Email: advance@advanceuv.com.au
INSTALLATION AND MAINTENANCE MANUAL FOR
ADVANCE F SERIES WATER DISINFECTION UNITS
ADV F Manual c50 1407
ADVANCE UV SYSTEMS PTY LTD
COVERING MODELS:
ADVANCE F30, F60, F90, F120,
ADVANCE F35, F70, F105, F140
ADVANCE F50, F100, F150, F200
Unit 22 / 17a Amax Ave, Girraween, NSW 2145
and
and
1/7
ABN: 73 167 590 730
.
.
.
Advertisement
Related Manuals for Advance acoustic F30
Summary of Contents for Advance acoustic F30
- Page 1 Ph: 02 9896 1165 Fax; 02 9896 4465 Email: advance@advanceuv.com.au INSTALLATION AND MAINTENANCE MANUAL FOR ADVANCE UV SYSTEMS PTY LTD ADVANCE F SERIES WATER DISINFECTION UNITS COVERING MODELS: ADVANCE F30, F60, F90, F120, ADVANCE F35, F70, F105, F140 ADVANCE F50, F100, F150, F200 ADV F Manual c50 1407...
- Page 2 GENERAL SAFETY INSTRUCTIONS Use the UV system only for the intended purpose as described in this guide. Correctly install your ADVANCE F series UV disinfection system as per instructions in this guide. Do not use an ADVANCE UV disinfection system with damaged electrical cable/plug/switch. ...
- Page 3 If there is a risk of water hammer then precautions need to be taken to prevent water hammer from damaging the quartz thimble. The weight of the chamber when filled with water must be taken into consideration when mounting the unit.
- Page 4 REACTOR ASSEMBLY Quartz Thimble Installation: Care should be taken when handling the quartz thimble. It breaks in the same way glass does and will have dangerous sharp edges if broken. It must be cleaned with methylated sprits to remove and finger marks or grease before installation.
- Page 5 Push the lamp all the way into the chamber as far as it will go, and then secure the end cap in place with the three screws provided. IMPORTANT: if the chamber is vertical then the UV lamp must be held securely at all times until the lamp is in place. If the UV lamp is dropped into the quartz thimble, then both the thimble and the UV lamp may break.
- Page 6 SERVICING Servicing should be carried out by a qualified and competent service technician. The UV unit must be switched off electrically isolated as well as being hydraulically isolated and depressurized before servicing. Servicing the UV Lamp: Ensure the unit has been switched off and isolated. ...
- Page 7 SPARE PARTS Model UV lamp Quartz Thimble O ring ADVANCE F30 LL180-S4 QD121028 O28-FA ADVANCE F60 LL180-S4 QD121028 O28-FA ADVANCE F90 LL180-S4 QD121028 O28-FA ADVANCE F120 LL180-S4 QD121028 O28-FA ADVANCE F35 LL235-S4 QD121028 O28-FA ADVANCE F70 LL235-S4 QD121028 O28-FA ADVANCE F105...
Need help?
Do you have a question about the F30 and is the answer not in the manual?
Questions and answers