NAD 5120 Instructions Manual
Semi-automatic belt-drive turntable
Hide thumbs
Also See for 5120:
- Service manual (16 pages) ,
- Instructions for installation and operation manual (13 pages) ,
- Instructions for installation and use manual (12 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Need help?
Do you have a question about the 5120 and is the answer not in the manual?
Questions and answers
The rubber band fell of during transporting the turntable. I need a diagram to put it back in place
To reattach the rubber band (drive belt) on the NAD 5120 turntable:
1. Remove the mat and lift off the subplatter.
2. Place the rubber band around the inner rim of the subplatter.
3. Hold the belt in place and carefully lower the subplatter back onto the spindle.
4. Through the access hole on the subplatter, stretch the belt to loop it around the motor pulley.
A diagram would show:
- The belt looped around the inner rim of the subplatter.
- The belt also looped around the small motor pulley located to the side.
This setup allows the motor to spin the subplatter via belt drive.
This answer is automatically generated