Advertisement
Quick Links
Advertisement
Summary of Contents for OmniPro OP-200
- Page 1 OP-200 FM HANDHELD TRANSCEIVER INSTRUCTION MANUAL www.omnipro.ca...
- Page 2 NOTE： NOTE： INSTRUCTION MANUAL OP-200 FM HANDHELD TRANSCEIVER 167W06000423...
- Page 3 Before using this radio, read this operating Due to the update or modification of the product, instruction carefully for safe and convenient OMNIPRO owns the right to change the usage. When you begin to use it, we deem that specifications of software and hardware described you have read this manual.
- Page 4 To avoid of the problems caused by electromagnetic Do not place the radio under the direct sunlight or Battery Do not insert the battery pack into the charger interference or electromagnetic compatibility, near the area with heating devices. All batteries can cause property damage and/or when charging is not necessary.
- Page 5 Contents Unpacking and Checking Low Battery Warning .........10 Unpacking and Checking..........2 Squelch Level............10 Unpack the radio carefully. We recommend that you Preparation..............3 CTCSS/DSC............10 check the radio and the supplied accessories listed in Charging the Battery..........3 Voice Annunciation..........10 the following table before discarding the packing Antenna OPA-C200 Charging State Indication.
- Page 6 Charging Power supply Abnormal Plug the power adapter into an OPA-B200H Li-ion battery of OMNIPRO is applicable to this radio. No battery applicable AC outlet and connect Pre-charging There is a built-in protective circuit in OPA-B200H. When the the power adapter to the battery charger. Green LED lights.
- Page 7 Installing the Antenna 1.L ED indicator Installing/Removing the Belt Clip hear the noise. Hold the base of the antenna and turn the Red LED lights when transmitting; green LED lights when 7.S peaker/MIC jack When installing, match the two antenna clockwise into the connector on receiving.
- Page 8 Selecting a Channel transmitting channels used have the following options: Press PTT button, the radio will transmit from the priority Scan function Turn the channel selector knob to your 1. Last Rx channel channel in the scan list. Scan ON desired channel.
- Page 9 2. Press Monitor button, Red LED flashes, and start to clone its overtime activity. CTCSS/DSC of OP-200 can be programmed by PC software. If the radio hasn't receive any signal or no operation is being the data. Red LED lights off when finishing clone.
- Page 10 Note: You can enable or disable wired clone function by PC Status setting (by the dealer) Major specifications are heard on the CTCSS/DCS signal of all radios in software. Once this function is disabled, the radio cannot enter Model: Serial No.: channel.
- Page 11 2. The way to resume scanning after its pause: Time Operate Carrier Operate NOTE： NOTE： NOTE： 3. Revert channel: Selected Channel Selected Channel or Currently Working Channel Priority Channel Priority Channel or Currently Working Channel 4. Squelch 5. TOT 6. Auto scan...
Need help?
Do you have a question about the OP-200 and is the answer not in the manual?
Questions and answers