Page 1
Mono Blocks: SAEv4 600D SAEv4 2000D SAEv4 1000D SAEv4 3000D SAEv4 1500D SAEv4 5000D Multi - Channel SAEv4 100.4 SAEv4 200.4 SAEv4 150.4 SAEv4 900.5 This manual is intended to be a guide, installation by a qualified professional is recommended.
Page 2
DIGITAL MONOBLOCK FEATURES § Digital Class-D Mono Block Amplifier § 4 Way Protection Circuit (Thermal, § Dual MOS-FET PWM Power Supply Voltage Speaker short and DC Offset) § 1 Ohm Stable Load § Wired Remote Control with Clipping § 12 dB/Octave - Variable Low Pass Filter Indicator.
Page 3
MULTI-CHANNEL FEATURES FULL RANGE DIGITAL FEATURES § High Fidelity Class A/B Multi-Channel § Clipping Indicator High Fidelity Class A/B Multi - Channel Clipping Indicator Design § 4 Way Protection Circuit (Thermal, Design 4 Way Protection Circuit (Thermal, §...
Page 4
WHAT DO ALL THE SWITCHS, KNOBS AND LIGHTS DO? CH1-CH5 RCA’s: RCA signal from source CH1-CH5 SPEAKER OUTPUTS- This is where your speakers plug in, see the amp specific diagrams for assistance. GAIN- NOT A VOLUME KNOB, THE INTERNET IS LYING TO YOU , used to set the input signal levels, start from Min and slowly turn clockwise until you hear angels singing or the sirens from the cops looking for you.
Page 5
POWER CONNECTIONS +12V Battery You need to connect a power wire to the vehicle’s positive battery terminal. This connection must be tight and secure to ensure proper connectivity. This wire must be fused appropriately (see each amplifier’s fuse rating under specifications) within 12 to 16 inches for safety. You will then need to connect the power wire to the 12+ terminal of the amplifier with a Phillips screwdriver.
Page 6
MONOBLOCK INPUT AND SPEAKER CONNECTIONS SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 7
4 CHANNEL FULL RANGE INPUT AND SPEAKER CONNECTIONS 4 CHANNEL FULL RANGE INPUT AND SPEAKER CONNECTIONS PROT POWER GAIN X-OVER 40Hz 5KHz FULL 40Hz REMOTE 0.2V GAIN X-OVER 40Hz 5KHz 40Hz 0.2V FULL INPUT BRIDGE +12V BRIDGE SPEAKER OUTPUT POWER INPUT SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1 SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 8
4 CHANNEL BRIDGE MODE FULL RANGE INPUT AND SPEAKER CONNECTIONS Bridge mode examples for Series and Parallel wiring. SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 9
4 CHANNEL BRIDGE MODE FULL RANGE INPUT AND SPEAKER CONNECTIONS Bridge mode example using a Dual Voice Coil Subwoofer. SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 10
5 CHANNEL FULL RANGE INPUT & SPEAKER CONNECTIONS SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 11
SERIES/PARALLEL WIRING OF DUAL COIL SUBWOOFERS Subwoofer planning When using more than one subwoofer, you have to make sure your total impedance does not go below the minimum level of the amp, see the specification charts for your amplifier’s minimums. Use the chart below to help with your design.
Page 12
PARALLEL WIRING OF DUAL COIL SUBWOOFERS SERIES WIRING OF DUAL COIL SUBWOOFERS SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Page 13
At the sole discretion of Sundown Audio your amplifier will be either repaired, replaced, or offered to be exchanged for a different item of like kind and quality when it is being covered under warranty. In the event of shipping damage due to improper packaging on products being returned to Sundown Audio, the customer is liable of the cost of all damages, necessary repairs, or replacement.
Page 14
TROUBLESHOOTING All Sundown Audio amplifiers have multi-layer protection features to prevent damage from misuse or faulty conditions to ensure long lasting life of your investment. If the unit senses excessive heat, short circuited speakers, overload, or voltage fluctuation outside of the working range the protection indicator light will turn red and the unit will turn off.
Page 15
514 W 21st Street, Newton, NC 28658 (828) 459-1980 Find us on: WWW.SUNDOWNAUDIO.COM SAEv4 SERIES AMPLIFIER OWNER’S MANUAL version 1.1...
Need help?
Do you have a question about the SAEv4 600D and is the answer not in the manual?
Questions and answers