Page 1
UV-MASTER 1000W ECG IP65 Daylight LIH14032967/ LIH14032907R9/ LIH14032907R6/ LIH14032907R1/ Rated power output 1000W Protection class UV Master: IP65 (dust tight, protected against high pressure water jets from any direction) Protection class ECG: IP65 Protection type Impact resistance IK 08 UV lamp included...
Page 3
Then carefully tighten the 6 bolts. Broken front screens have to be replaced immediately; use original LIH screen only (code 14041964). Safe operation of your UV Master can be guaranteed only if all operating instructions will be applied.
Page 4
Warning: when mounting the lamp make sure the protuberance “T“(exhaust tube) does not point downwards facing the front screen! Insert the UV lamp tightly in the steel springs “S” of socket “P”. Then connect the stranded wire to the electrical contact of the socket. www.lih.de...
When all cables are connected, make sure that there is no bare copper protruding out of the clamps. Tighten the ring nut of the cable gland using a model 27 wrench. Make sure the screws of the connection box are tight, and the frame seal is seated firmly in the notches. www.lih.de...
It can be restarted, though, after cooling down. Only LIH ignition devices with the marking IGZ12 may be used. They must be connected according to the wiring diagram. Never change the wiring inside the switch cabinet! Open the cabinet only after disconnecting it from the power supply.
Page 7
Always switch off your UV Master and allow it to cool off before cleaning Any failure to comply with these instructions may cause severe burn injuries or make the protective screen burst! LIH Light Impex Henze GmbH Bgm.-Schwaiger-Straße 43 D-85567 Grafing bei München Germany Tel.: +49/(0)8092 709957...
Need help?
Do you have a question about the LIH14032967 and is the answer not in the manual?
Questions and answers