Subscribe to Our Youtube Channel
Summary of Contents for NOMA SurfaceElite+
- Page 1 SurfaceElite+ Cordless Hard Floor Wet Vacuum Cleaner PRODUCT NO. 043-7198-6 USER MANUAL READ AND SAVE THESE INSTRUCTIONS NOMA Customer Support: 1-866-827-4985 ®...
- Page 2 SAFETY / CAUTIONS IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE ASSEMBLING OR USING YOUR HARD FLOOR CLEANER. When using an electrical appliance, basic precautions should be observed, including the following: WARNING proofing substances, the cord. • flammable dust, or other Do not handle storage TO REDUCE THE RISK OF FIRE, explosive or toxic vapours.
- Page 3 1-866-827- cleaning solution, use after use. The storage 4985 for assistance. NOMA Multi-surface base should be placed ® • Have service performed Hard Floor Cleaning against the wall.
- Page 4 • • • This appliance can Children shall not play You are responsible for be used by children with the appliance. making sure that your • aged from 8 years and Cleaning and user hard floor cleaner is not above and persons with maintenance shall not used by anyone who reduced physical, sensory...
- Page 5 TABLE OF CONTENTS A. KNOW YOUR HARD FLOOR CLEANER B. OPERATING INSTRUCTIONS C. CLEANING INSTRUCTIONS D. PRODUCT SPECIFICATIONS E. TROUBLESHOOTING F . WARRANTY & DISPOSAL...
- Page 6 KNOW YOUR HARD FLOOR CLEANER FEATURES SELF-CLEANING BUTTON MODE BUTTON POWER BUTTON HANDLE DISPLAY SCREEN MAIN BODY DIRTY WATER TANK (DWT) RELEASE BUTTON DIRTY WATER TANK (DWT) BRUSH ROLLER WINDOW BRUSH ROLLER CLEAN WATER TANK (CWT) RELEASE BUTTON CLEAN WATER TANK (CWT) BRUSH ROLLER (X2, WITH 1 PREINSTALLED) STORAGE BASE ACCESSORY HOLDER...
- Page 8 DISPLAY SCREEN Outer Ring Suction Power Water Spray Amount Tilt Vacuum Brush Roller Self-cleaning Battery Status Brush Roller Air Drying Battery Indicator DWT Full of Water Brush Roller Tangled Dirty tank full CWT Lack of Water INDICATORS When in Use Meaning When in Use Meaning...
- Page 9 OPERATING INSTRUCTIONS SET UP DIRECTIONS ASSEMBLY Your SurfaceElite+ Cordless Hard Floor Wet Vacuum Cleaner comes in four easy-to- assemble components and does not require any additional tools to assemble. • Handle • Accessory Holder • Main Body • Storage Base Click Hole Insert the handle into the top of the main body until you hear a “click”.
- Page 10 CHARGING AND BRUSH ROLLER AIR DRYING WARNING Before charging make sure the hard floor cleaner is turned OFF. Ensure the dirty water tank is empty. Charging Port Insert the charging adapter into the charging port located on the back of the storage base.
- Page 11 Optional: If you want to stop roller from air drying, press the air dry button located on the storage base as shown. The air dry light turns off. The roller air drying indicator on the display screen turns off. NOTE: The charging process continues. When the hard floor cleaner has been fully charged (100%) and the roller air drying has completed, the display screen turns off.
- Page 12 FILLING THE CLEAN WATER TANK Clean Water Tank (CWT) Release Button Press the clean water tank (CWT) release button to remove the clean water tank from the cleaner. Tank Cap Open the tank cap on the back of the Fill the clean water tank with tap clean water tank.
- Page 13 WARNING • To reduce the risk of fire and electric shock due to internal component damage, use the provided cleaning formula intended for use with the hard floor cleaner. Once depleted, call 1-866-827-4985 to purchase a new cleaning formula. • Only use water under 104F° (40°C). DO NOT USE HOT WATER. •...
- Page 14 NOTE: When the hard floor cleaner is in the upright position, pressing the power button cannot start the cleaner. The tilt vacuum indicator on the display screen will flash for 5 seconds. Recline the cleaner for operation. Mode Button Standard Mode Max/Mopping Mode Suction Mode Pressing the mode button will switch the...
- Page 15 NOTE: After pressing the power button, the brush roller stops immediately. The cleaner still keeps on to vacuum dirty water on the floor. After 3 seconds, the cleaner turns off. Once you have completed cleaning, press the power button to stop the hard floor cleaner and put the hard floor cleaner back in the upright position.
- Page 16 EMPTYING THE DIRTY WATER TANK Empty the dirty water tank when the DWT full indicator flashes. During normal use, debris may accumulate in the dirty water tank. For best performance, empty and rinse the dirty water tank after each use. Never operate the hard floor cleaner without the dirty water tank and filter in place.
- Page 17 Fill Tubes Wash the tank lid and fill tubes with Reinstall the tank lid to the dirty water clean water and allow to air dry. Make tank, and then place the filter onto the tank lid. sure the visible dirt on the fill tubes is cleaned up.
- Page 18 CLEANING INSTRUCTIONS CARE & MAINTENANCE WARNING To reduce the risk of an electric shock, ensure the hard floor cleaner is turned off before performing any maintenance. WARNING Do not operate the hard floor cleaner without filters in place. BRUSH ROLLER SELF-CLEANING WARNING •...
- Page 19 Air Dry Light NOTE: While the brush roller is Air Dry Button self-cleaning, press the self- cleaning button again; self- cleaning will stop and the DWT full indicator will flash. Empty and clean the dirty water tank While the brush roller is self-cleaning, immediately to avoid odour.
- Page 20 BRUSH ROLLER AIR DRYING Place the hard floor cleaner on the Ensure the storage base is plugged in. storage base to air dry the brush roller The cleaner will automatically charge for about 4 hours after cleaning. and air dry the brush roller. See instructions in CHARGING AND BRUSH ROLLER AIR DRYING (page 10-11).
- Page 21 “ Click ” Replace the brush roller cover to the floor head until you hear a “click”. When replacing, always latch the brush cover into place to avoid leakage. CLEANING & REPLACING THE BRUSH ROLLER Brush Roller Tab Brush Roller Cover Release Button Remove the brush roller cover from Remove the brush roller by grabbing...
- Page 22 Wash the brush roller with clean water. Put the brush roller into the accessory holder, and allow it to dry completely before reinstalling. “ Click ” Reassemble the other brush roller to Replace the brush roller cover to the the floor head until you hear a “click”. floor head until you hear a “click”.
- Page 23 PRODUCT SPECIFICATIONS OVERVIEW NOMA SurfaceElite+ Cordless ® Product Name Hard Floor Wet Vacuum Cleaner Product Model 043-7198-6 Voltage 22.2 V Clean Water Tank Capacity 700 mL Net Weight 5.9 kg (13 lb) 693 x 320 x 324 mm Product Dimensions (LxWxH)
- Page 24 TROUBLESHOOTING COMMON PROBLEMS If you have any problem with the product, please complete simple user checklist before contacting NOMA Customer Support: 1-866-827-4985 ® COMMON SUGGESTED POSSIBLE CAUSES PROBLEMS SOLUTIONS Charge the hard floor Battery may be depleted. cleaner as instructed on page 10-11.
- Page 25 10-11. Please do not return this product to store. For difficulties, questions or concerns, call NOMA ® customer service at 1-866-827-4985 and a member of our team will be happy to help you!
- Page 26 WARRANTY & DISPOSAL ENVIRONMENTALLY FRIENDLY 3-YEAR LIMITED WARRANTY product is guaranteed for a period of three (3) This NOMA ® years from the date of original retail purchase against defects in workmanship and materials, except for the following components: a) Component A: Batteries and chargers, which are guaranteed for a period of two (2) years from the date of original retail purchase against defects in workmanship and materials;...
Need help?
Do you have a question about the SurfaceElite+ and is the answer not in the manual?
Questions and answers