Pinegreen Lighting CL-BLD2D5K-3CCT Installation Instructions

INSTALLATION INSTRUCTIONS: CL-BLD2D5K-3CCT | 5000 LUMEN DUSK TO DAWN BARN LIGHT
PRECAUTIONS:
Please read and understand this entire manual before installing or operating this light fixture.
• Read all instructions before installation, then store in a safe place for
future reference. Failure to do so may result in faulty assembly
and potential injury.
• This light fixture should be installed outdoors to a wall or a pole.
• Do not immerse components in liquid.
• This light is water-resistant.
• Never look directly into the light when illuminated.
• This product is designed to operate in temperatures ranging from
-40 F to 104 F (-40 C to 40
o o o
• If you are unfamiliar with electrical installation contact a qualified
electrician.
WARNING: Before installation or servicing, turn the power OFF at the circuit breaker or fuse. Place tape over the circuit breaker switch
and verify power is OFF at the light fixture.
WARNING: Risk of fire. Keep the lamp heads at least 3 inches from combustible materials.
CAUTION: Burn hazard. Allow the light fixture to cool before touching.
CAUTION: Do not mount the fixture upside down.
HARDWARE:
Light fixture x1
TOOLS REQUIRED:
NOT INCLUDED
Power Drill
Silicone Sealant
If you have questions or are missing parts, please contact customer service at 1-888-745-4837
C).
o
A
A
D
D
1/8" Drill Bit
Phillips Screwdriver
TO AVOID ELECTRICAL SHOCK, MAKE SURE TO TURN
OFF THE MAIN POWER SOURCE OR DISCONNECT POWER
Wire Nuts
x3
Wall Anchors
x3
Ladder
Flathead Screwdriver
Electrical
Tape
PLEASE READ ALL INSTRUCTIO
—
To prevent personal injury or product
WARNING:
—
To avoid electric shock or component
—
RISK OF ELECTRICAL SHOCK.
Disconnect product and allow cooling
—
Any alteration or modification of this p
—
DURING THE INSTALLATION OR SERVICE To prevent product malfunction and/o
OF THIS PRODUCT
—
This luminaire is designed to operate
—
CONSULT A QUALIFIED ELECTRIC
DTD LED BARN LIGHT
Pole Mounting
1. Select desired CCT & Power and
B
B Washers
2. Remove Bar-type Bracket.
x3
3. Feed wires through the lamp-pos
4. Mount lamp body to pole, and att
E
Bar Bracket x1
5. Drill holes on the wall, and put in
E
6. Place the self-tapping screws into
7. Installation completed.
Safety Glasses
Bar -type
Bracket
Wire Stripper
C
C
Self-tapping
Screws x 3
F
Square
F
Bracket x1
CCT &
Select M
Level
1