Page 1
0222V00000 115VAC/75 B A L A N C E D , M O D U L A R F O R K B E A R D + A U T O N O M Y D A C...
Page 2
2. Never use this device near water, and clean only with so well, maybe if Gungnir 2 was a living a dry cloth. 3. Assure adequate ventilation, do not block any ventila- thing—no, nevermind, let’s get back...
Page 3
Place Gungnir 2 in a cool, well-ventilated ABOUT DRIVERS area. Gungnir 2 runs pretty warm. We don’t Schiit’s Unison USB™ is UAC2 compliant, recommend “stacking” it directly on top of, which means it does not need drivers for or under, components that generate a lot modern streamers or computers.
Page 4
OUTPUTS 1 RCA and XLR outputs. Connect either or both of these outputs to your preamp or integrated amp using high-quality MULTIFORM XLR (balanced) or RCA (single-ended) cables. “R” is right, “L” is left. XLR is true differential output; do not short either hot or cold pins.
Page 5
GUNGNIR 2 0A1234567 115VAC 30W POWER CONTROL 7 Power switch. Up for on, down for off. Simple 9 Forkbeard port. Plug a Forkbeard module as that. However, it won’t work unless you have in here to enable remote control via the app, a power cord plugged in (below).
Page 6
1 Mode select. This button allows you to 2 Inverted phase indicator. When this LED select inverted phase and NOS mode, to is on, Gungnir 2 is inverting phase. This is compensate for inverted recordings or to helpful for some recordings.
Page 7
EN A B LE D the Forkbeard module, using the Forkbeard app. inputs. Stop on the one you want to listen to. Please visit schiit.com/forkbeard for currently 5 Input indicators. These indicate the se- supported platforms and Forkbeard-specific lected input. In order: Unison 192, Unison 384, information.
Page 8
An IR remote control is included with Gungnir 2. You may also choose a Forkbeard module for more advanced remote control, reporting, and integration. 1 Input select. You can step forward and back through the inputs with the IR remote. Whee! 2 Phase invert.
Page 9
I hear hum from Gungnir 2. What do I do? I don’t get any sound from Gungnir 2! Gungnir’s noise floor is insanely low, so it’s Are your sources on? Check those first. If most likely a ground loop. To fix a ground you’re using a computer source, ensure that...
Page 10
Schiit Audio warrants to the original purchaser that this product shall be free from defects in material and workmanship for five (5) years from the date of purchase. If a defect covered by this warranty occurs during this period, Schiit Audio will repair the defective product, free of charge.
Page 11
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 12
(0) ESS, AKM, or other standard DACs (0) Standard digital filters (Various) Stickers and stuff (Infinite) Appreciation from the whole Schiit crew in San Antonio and Corpus Christi (Even more) Thanks from our chassis and PCB guys in California, Nevada, and Utah.
Need help?
Do you have a question about the Gungnir 2 and is the answer not in the manual?
Questions and answers