Advertisement
Quick Links
MODEL
RBA2760-001
RBA2760-002
RBA2760-032
RBA2760-033
Sourced/ Supplied under QMS
The illustrations and descriptions herein are applicable to production as of the date of this Installation Instructions Sheet. Revised 07/24 © 2024 by RBA Group II/RBA2729-Series /0724
1 of 8
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
RECESSED WATER COOLERS
Recessed Drinking Fountain w/ Bottle Filler | Flexi Bubbler
Recessed Drinking Fountain | Stainless Bubbler
Recessed Water Cooler | Stainless Bubbler
Recessed Water Cooler | Flexi Bubbler
As improvements in the design and performance of RBA products are continuous, specifications may be subject to change without notice.
SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for rba RBA2760-001
Summary of Contents for rba RBA2760-001
- Page 1 As improvements in the design and performance of RBA products are continuous, specifications may be subject to change without notice. The illustrations and descriptions herein are applicable to production as of the date of this Installation Instructions Sheet. Revised 07/24 © 2024 by RBA Group II/RBA2729-Series /0724...
- Page 2 Provide 102mm minimum clear space on fixture sides to allow for proper ventilation through cabinet louvers. Due to cold waste water, we recommend the trap supplied by installer be insulated to prevent excessive condensation. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 2 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
- Page 3 *Dimensions shown are for recommended adult height. Adjust vertical dimensions as necessary to comply with local codes. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 3 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
- Page 4 10. Fixture operated within water pressure range of 200-500kPa. RBA will not warrant chillers damaged when connected to supply lines with flow pressure below 200kPa or above 500kPa. 11. Due to cold waste water, RBA recommends that waste piping supplied by installer be insulated appropriately to prevent excessive condensation.
- Page 5 3. Recheck all water and drain connections with water flowing through system. 4. Install removable access cover using supplied #8-32 screws and washers. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 5 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
- Page 6 Push-In Fitting Body and hold. While holding the Collet in, pull on the PE Tubing to remove from the Push-In Fitting. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 6 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
- Page 7 Check the compressor mounting to make sure the pins and clips are not rattling. If the compressor appears to be noisy internally, it must be replaced. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 7 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
- Page 8 Important: Installation Instructions are subject to change without notice. Please visit our websites for latest revision. SYDNEY | MELBOURNE | BRISBANE | PERTH | AUCKLAND 8 of 8 Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz...
Need help?
Do you have a question about the RBA2760-001 and is the answer not in the manual?
Questions and answers