Solight 1MN20 Instruction Manual

Flat Panel TV Wall Mount Instruction Manual – Solight 1MN20
NOTE: We recommend that this product is installed by the professional only. We accept no liability for damages
caused by incorrect assembly, installation or use. If there is any doubt, please contact the specialist from the
seller for help.
IMPORTANT!
• For safety reasons, the wall or mounting surface must be capable of supporting the combined weight of the mount and
the display; otherwise the structure must be reinforced.
• Safety gear and proper tools must be used. Failure to do so can result in property damage and/or serious injury.
• Make sure that no electrical cables,water pipes or gas pipes are located within the wall.
Tools required for the installation:
• Phillips Head Screw Driver
• Electric or Portable Drill
•
Ratchet Driver with 1/2" (13 mm) Socket
Also make sure that all of the hardware has been included with your mount.You should find the following:
(A) M8x63 Lag Bolt x 4
(D) M4x12 Bolt x 4
(G) M6x12 Bolt x 4
(J) M8x12 Bolt x 4
Installing the wall mount
Drywall installation
1.
Center of the stud
Stud finder
2.
(B) Concrete Anchor x 4
(E) M4x25 Bolt
(H) M6x430 Bolt
(E) M8x30 Bol
Tape measure
Use the spirit level and pen
to mark the hole positions
• 1/4" (6 mm) Drill Bit + Stud Finder (Drywall
Installation)
• 7/16" (11 mm) Masonry Bit (Concrete Installation
x 4
x 4
x 4
Concrete / Brick installation
1.
2.
(C) Lag bolt washer x 4
(F) Large spacer x 4
(I) M6 washer x 4
(L) Small spacer x 4
Tape measure
Use the spirit level and pen
to mark the hole positions