Download Print this page

Advertisement

Quick Links

AW JR Handset Installation Manual
E. F. Bavis & Associates, Inc.
201 Grandin Road
Maineville, Ohio 45039
(513) 677-0500
Copyright 2009 E. F. Bavis & Associates, Inc.
Revised 4/14/2009
All Rights Reserved
P/N 00742011

Advertisement

loading
Need help?

Need help?

Do you have a question about the AW JR and is the answer not in the manual?

Questions and answers

Summary of Contents for E. F. Bavis & Associates AW JR

  • Page 1 AW JR Handset Installation Manual E. F. Bavis & Associates, Inc. 201 Grandin Road Maineville, Ohio 45039 (513) 677-0500 Copyright 2009 E. F. Bavis & Associates, Inc. Revised 4/14/2009 All Rights Reserved P/N 00742011...
  • Page 3: Table Of Contents

    Table of Contents Bill of Materials ........................1 Tools Needed........................2 Installing Microphone Cables ..................... 2 Installing Speaker Wiring....................3 Mounting Handset and Hook Assembly ..............…...5 Completed Wiring Diagram ..................…...7...
  • Page 5: Bill Of Materials

    Bill of Materials Part Description Quantity Number Not Complete at This Time...
  • Page 6: Tools Needed

    Tools Needed Medium Phillips Screwdriver Drill 7/8” Drill Bit/Uni-bit/Hole Punch Wire Cutters Wire Connector Crimpers #8 Spanner Bit Electrical Fish Tape or Stiff Wire Microphone Cables Installation 1. Remove the call button to gain access to wire chase.  To remove the button on older windows where the thin “Call Button” label is affixed directly to the face of the window frame, the button “snaps”...
  • Page 7: Installing Speaker Wiring

    3. Fish the two new mic cables through the call button hole up to the mic hole so that the connector on one cable is different than the connector on the other cable. 4. Connect one cable to the microphone lead and the other to the pre-amp/extension cable that runs back to the audio board.
  • Page 8 5. Using the inline splices provided, connect cable with the large connector and male pins to the cable going back to the audio board. 6. Reinstall the speaker.
  • Page 9: Mounting Handset And Hook Assembly

    Mounting the Handset and Hook Assembly 1. Before mounting the back plate, drill a 7/8” hole, 1-1/4” to 1-3/8” to the right of the center 7/8” hole to route the wires through. ALUMINUM BACK PLATE 1-1/4" TO 1-3/8" DRILL 7/8" DIA. HOLE 2.
  • Page 10 3. Connect all wires to the appropriate connectors including the call button. 4. Tuck excess wire back into the window frame. 5. Mount the cover with the handset and hook onto the back plate. 6. Test audio system. For additional help or information contact EF Bavis & Assoc. (513) 677-0500...
  • Page 11: Completed Wiring Diagram

    Completed Wiring Diagram...