Summary of Contents for Teton Grill XKF Series
- Page 1 XKF SERIES PROFESSIONAL POND & KOI FILTER INSTRUCTION MANUAL MODEL VERSION XKF2500 NOVEMBER 2024 XKF4200 XKF6500 Teton Dynamics XKF9000 P.O. Box 1044 XKF12000 San Leandro, CA 94578-0031 XKF16000 XKF24000...
-
Page 2: About The Product
• Teton XKF Series Teton fiberglass filters are designed to work with water at a temperatures greater > than 32degrees F/ 0 ° C and less < than 105 degrees F/40 ° C. The filter should never be operated outside of these temperatures or damage may occur. -
Page 3: Technical Specifications
• Chemical spills and fumes can weaken filtration Swimming Pool / Spa equipment. Corrosion can cause filters and other equipment to fail, resulting in severe injury or property damage. Do not store pool chemicals near your equipment. Basic safety precautions should always be followed, including the following: Failure to follow instructions can cause severe injury and/or death. -
Page 4: Installing The Filter
Installing valve to filter (XKF12000/16000/24000) Align the intake and discharge unions with the two ports on the side of the tank. 2. Make sure the o-rings are seated correctly. 3. Tighten the unions onto the ports. Note: XKF2500-9000 come with valves pre-installed. Installing the filter Position the filter as close to the pond as possible. -
Page 5: Multi-Port Valve Operation
Backwashing & Rinsing the filter This function allows the filter to discharge larger debris on a regular basis to reduce the workload on the bacteria colony and help maintain a clean and healthy pond. The frequency of backwashing can depend on the amount of fish and the feed rate. -
Page 6: Maintenance
MAINTENANCE Winterizing If your filter is above ground: Switch off the Pump/ Close the Inlet Valve, 2. Open the air release valve and move the MPV handle to the winterize position [between Filter and Waste] This will allow air to pass through to all ports. 3. -
Page 7: Limited Product Warranty
LIMITED PRODUCT WARRANTY • CMT Group LLC, a California limited liability company d/b/a Teton™ (the “Company”) expressly warrants to the original purchaser that, for a period of two (2) years from the date of sale, the covered product (the “Product”) will be reasonably free of defects in materials and workmanship and that when property handled, will conform, within accepted tolerance to applicable manufacturing specifications.
Need help?
Do you have a question about the XKF Series and is the answer not in the manual?
Questions and answers