Labor Pro B271 Instructions

B271 - LABOR PRO - ENGLISH
Please read carefully all the instructions contained in this booklet as they provide important
advices about safety, use and maintenance. This appliance can be used by children aged from
8 years and above and persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing
water.
FEATURES
- Lenght: 23cm
- Weight: 240g
- Temperature:190°C
- Double Voltage
SAFETY ADVICES
Caution: The metal plates and coils are very hot, and any contact with them causes burns.
Danger: do not leave the packaging (plastic bags, cardboard boxes, staples) within the reach
of children, as it is a potential source of danger. Please check the power supply of the electric
socket before using the product. Make sure the voltage of the electric socket is the same as
that of the appliance. Caution: the rod gets very hot, any contact with the skin will result in
burns. In the event of the product being dropped, check that there is no visible damage before
any further use. Since it is a professional appliance, if it has been damaged, please contact
only an authorised service centre to have it repaired. To avoid dangerous overheating, do not
keep the appliance switched on unnecessarily when not in use. Never immerse the appliance
in water. Risk of electric shock. NEVER touch the appliance with wet or damp hands and/
or feet. Do not use extension cables. Do not use in public bathrooms or showers. After use,
disconnect the appliance from the socket by pulling the plug and not the power cable. Do not
leave the appliance exposed to the weather (rain, sun, etc..).
Warning - Danger: do not put the appliance close to your face or eyes, there is a danger this
could result in burns. Always keep the rod clean from dust, dirt, hair sprays and gels. After use,
always unplug the appliance and wait until the rod has completely cooled before storing it.
INSTRUCTIONS
1. Plug the appliance
2. Put the switch on "ON" position, the light will turn on.
3. Wait a few minutes and the iron is ready for use.
4. Take a lock of hair insert between the two ends of the device, then press in position for a
few seconds.
5. Repeat this operation with every lock.
Avoid contact between the metal parts and your skin: Danger of scalds or burns.
Be careful not to place the iron on surfaces that could catch fire, as a fire hazard.
PACKING AND MAINTENANCE
After removing the packaging, check the integrity of the appliance. In particular, that the
appliance is intact and has no visible damage that could have been caused in transport.
If in doubt, do not use the appliance, and contact only an authorized service centre. This
appliance must only be used for the purpose for which it was specifically designed, i.e. as a
hair curler. Any other use should be considered inappropriate and therefore hazardous. The
manufacturer cannot be held liable for any damage resulting from improper or incorrect use.
To avoid dangerous overheating, do not wrap the power cord around the appliance. Before
using the appliance, ensure that it works perfectly, any defects may cause damage. In this
case the manufacturer can not be held liable. Before performing any cleaning or maintenance