Sealey CTI140 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT
IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE
WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Read the manual before using this product. Thoroughly understand operating procedures, safety warnings and maintenance
9
requirements. Keep the manual in a convenient place for all users to see and use. Keep labels as per original.
The compressor operates with a 12-volt electrical system or from integral battery.
9
Consult your vehicle's manual or a qualified mechanic for proper connection procedure.
9
After 30minutes of continuous operation, allow the unit to cool before restarting.
9
Damage can occur from continued overuse.
9
The compressor was permanently lubricated during assembly. DO NOT add oil or any other lubricant.
9
The unit will become HOT after using for a long period of time. When used for a long period of time, the compressed air hose and
9
device may become noticeably warm.
There is a risk of burn injuries! Allow the mini compressor to cool down sufficiently before storing.
9
Please use caution when touching the unit in order to avoid burns.
9
Only inflate tyres to the manufacturer's recommended pressure. DO NOT over inflate as serious injury could occur.
9
Keep the unit away from small children.
9
Clean with a damp cloth only. DO NOT use chemicals or soap.
9
DO NOT use the unit for pumping any gas or liquid other than air.
8
The unit is not designed for use as a source for breathable air.
9
The unit is designed for use with car tyres. It is not designed for use with large tyres like tractor or truck tyres.
9
DO NOT use (or modify) the tool for any other purpose than that for which it was designed.
8
The unit is fitted with safety auto stop feature but caution is advised to be prepared to stop the unit when pressure is reached.
9
The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that
9
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
Failure to heed these warnings may result in fatal personal injury and/or property damage.
9
2. INTRODUCTION
Rechargeable unit for portability and quick inflation anywhere, supplied with 12V plug for alternative power option when battery has run
flat. Power bank with USB output 5V 2A ideal for charging mobile phones and portable devices. Suitable for inflating tyres on cars, vans,
4x4s, motorcycles and bicycles. Maximum pressure 120psi. Pressure units psi, kPa, kg/cm² and bar. Auto stop feature. Airflow 0.68CFM
19L/MIN with an inflation time 0-30psi in 261sec (175/70/R13). Backlit LED digital display. 1W SMD LED worklight with strobe and SOS
light. Accessory kit includes 170mm extension tube with Schrader connection, Presta type adaptor, ball spike, inflatables adaptor, USB
charging cable and storage bag.
3. SPECIFICATION
Airflow:
Battery:
Battery Charge Time:
Battery Run Time:
Hose Length:
Inflation Time:
Maximum Air Supply:
Nett Weight:
Pressure Units:
Max Current:
USB Output:
12V Accessory Plug Length:
© Jack Sealey Limited
RECHARGEABLE/12V TYRE INFLATOR &
POWER BANK WITH WORKLIGHT
CTI140
MODEL NO:
0.68cfm 19l/min
2000mAh x 2
3-5 Hours
30 Minutes
170mm
0-30psi in 261sec (175/70/R13)
120psi
0.54kg
Psi, kPa, kg/cm² and bar
10A
5V/2A
3100mm
Original Language Version
CTI140 Issue 4 (3) 18/10/24