VELTOP Power Ride Mounting Instructions

Thank you for choosing the Veltop Power Ride model.
This product is designed, manufactured and assembled by CYCLO-SYSTEM, located in Haute-Savoie (74), France.
To ensure the correct use, operation and long life of your new accessory, please read and follow the instructions for use and assembly
carefully.
This model can be installed on all recumbent compatible with the front and rear fixations below.
Warning
Failure to follow these instructions could prevent the protection from working properly and cause certain parts to fail.
The effectiveness of the system would then be called into question and it could affect your travelling safety.
Choice of two rear fixations
Fixation on the luggage carrier
A choice of five front fixations
Tube support of Round boom fixation
derailleur with front motor or
pinion drive
Product content
x2
(tube version)
x4 x4
(windscreen version)
RK parts
Spacers x4 Spacers x2
(tube version)
Veltop Power Ride
Instructions of mounting
Fixation on the seat
armature tube
Square boom fixation
x4
Screws M6x35 x2
Screws M5x30 x2
(windscreen version)
Nuts x2 Plate
A choice of two front options
Tube version
Round boom fixation
without support of
derailleur
Allen key
Bracket
(tube version)
Velcro
Windscreen version
Round boom fixation
(Delta trikes)
Tube armature
Canopy