Lakeland Mills CF1155 Quick Start Manual

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to
the store. Call 1-800-427-5136 for customer service and we will save you time by correcting any problems
directly for you.
COMPONENTS
2– Top Rails
CF1155— 5 holes
CF1157— 7 holes
4– long legs
NOTE: Read all instructions before starting.
Use a rubber mallet (or a block of wood be-
tween the hammer and the unit) to drive dow-
eled ends into holes as far as possible.
STEP 1 Position two of the long legs on flat surface with
holes facing each other. Align three of the pre-
assembled inserts between the legs. Using a
mallet, or block of wood with a hammer, Tap the
Inserts into the legs. See Figure 1.
Repeat this process for remaining legs and inserts.
CF1155/CF1157 Cedar Log Arbor
Spindles
CF1155—5 pieces
CF1157—7 pieces
6– Preassembled
8—Angle
Side Inserts
Braces
NOTE: Cracks or Checks in
logs are part of the natural
beauty of cedar logs and should
not be considered defects.
HARDWARE AND TOOLS REQUIRED
OR
A battery operated or electric drill will make

assembly faster and easier.
Use a good quality penetrating oil or wood deck

sealer with a UV inhibitor and an anti-fungal.
(Make sure product is intended for outdoor use.)
If staining or finishing before assembling, tape

off all dowel ends. (Finishes will cause the dow-
els to swell, making assembly difficult.
38 - 2 1/2" Screws
OR
TIPS
FIGURE 1