Do you have a question about the SA-HD7-BIO and is the answer not in the manual?
Questions and answers
Summary of Contents for SPORTS AFIELD SA-HD7-BIO
Page 1
QUICK ACCESS BIOMETRIC SECURITY VAULT INSTRUCTION MANUAL FOR SA-HD7-BIO IMPORTANT: Please read this information and follow all safety rules carefully before operating your security vault. Failure to do so will void your warranty. 120823...
DISCLAIMER - READ BEFORE VAULT SETUP PLEASE READ THIS INFORMATION CAREFULLY BEFORE OPERATING YOUR SPORTS AFIELD VAULT. DO NOT LOCK THIS MANUAL OR THE OVERRIDE ACCESS KEYS IN YOUR VAULT. Thank you for choosing a Sports Afield vault to protect your valuables. We are committed to securing, organizing and protecting your most important documents, valuables and keepsakes.
1. REGISTRATION Register your vault at www.saproducts.com By registering your Sports Afield vault we will be able to expedite and address any problems or challenges you may have which would otherwise require a notary letter and proof of payment. REGISTRATION INFORMATION The information you record onto this page will be required in the event you cannot access the contents of your Sports Afield vault.
3. UNBOXING & INSPECTION Make sure to inspect your vault for shipping damage before accepting delivery. If you find any damage, please contact the delivery company (or carrier) immediately. Any damage not noted upon delivery must be reported within fifteen (15) days or there will be no recourse.
5. BATTERY INSTALLATION (Continued) Remove the empty battery tray from the compartment and insert the batteries in the correct position. WARNING: The batteries must be inserted with the correct polarity. Exhausted batteries must be removed from the product and discarded safely. Do not mix old and new batteries.
Page 8
6. PLACEMENT AND MOUNTING YOUR VAULT (Continued) Planning Your Space WARNING: THE BRACKET IS INTENDED TO BE USED WITH THE UNIT STANDING UP 3" NOTE: LEAVE 3" ABOVE THE UNIT TO USE YOUR BACKUP KEY 4" NOTE: LEAVE 4" BEHIND THE UNIT TO ACCESSS THE BATTERY COMPARTMENT Choose the ideal location...
Page 9
6. PLACEMENT AND MOUNTING YOUR VAULT (Continued) Using a 3/32" drill bit, drill pilot holes at the locations you marked in Step 2. Line up the mounting bracket with your pilot holes and use the provided hardware to secure your unit to the surface.
7. PROGRAMMING YOUR FINGERPRINT RESET BUTTON IS LOCATED AT THE TOP ON INSIDE 1. On the inside of the vault, at the top, you will a find a cover for the reset button. 2. Pull the reset button cover down BEEP to access the reset button.
8. OPENING VAULT WITH PROGRAMMED FINGERPRINT With keys in hand, close and lock the door. Place and hold the programmed finger on the scanner and indicator ring will illuminate green and you will hear one beep. The vault will slide open. If your print is not accepted: you will see 5 red flashes with 5 beeps.
9. PROGRAMMING ADDITIONAL FINGERPRINTS (Continued) HOLD FOR BEEP Press the reset button and follow Step 7 instructions again, for each fingerprint zone you would like to program. LIFT FINGER If you experience any problems reading your fingerprint, including inconsistent readings, note the area of your fingerprint that doesn’t work properly, and specifically re-program that area.
10. TROUBLE SHOOTING (Continued) PROBLEM SOLUTION Make sure to hold down your finger on the scanner instead of tapping, as the scanner needs time to YOUR FINGERPRINT complete the scanning process. IS NOT READING Fingerprints may lack definition due to excessive dryness. We recommend applying moisturizer or slide your finger print against your forehead before scanning process.
12. CLEARING ALL RECORDED FINGERPRINTS Hold Reset button. Initially, you RESET BUTTON IS will hear one beep. Continue HOLD DOWN THE LOCATED AT THE RESET BUTTON TOP ON INSIDE holding reset button for 5 seconds, the indicator ring will flash green two times and beep two times.
SA Consumer Products will repair or replace, at their sole discretion, any Sports Afield vault with defective parts, paint or lock for three years of the original owner purchase date. If SA Consumer Products deems a replacement vault is to be sent, they will pay the freight costs to ship the replacement vault to the original owner.
Need help?
Do you have a question about the SA-HD7-BIO and is the answer not in the manual?
Questions and answers