Fcc Compliance Statement - Sceptre X32BV-Naga User Manual

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions:
This device may not cause harmful interference
This device must accept any interference received, including interference that
my cause undesired operation.
Please Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
•
•
Caution: To comply with the limits for an FCC Class B computing device,
always use the signal cord and power cord supplied with this
unit.
The Federal communications Commission warns that changes or
modifications to the unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
European Notice
Products with the CE marking comply with both the EMC Directive
(89/336/EEC), (93/68/EEC) and the Low Voltage Directive (72/23/EEC) issued
by the Commission of the European Community.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- 93 -
www.SCEPTRE.com
SCEPTRE X32 HDTV User Manual