Connecting The Speakers; Connecting The Video Out To Your Tv - Samsung MAX-KX75 Instruction Manual

Connecting the Speakers

Before moving or installing the product, be sure to turn off the power and disconnect the power cord.
Connect the connecting jacks (2) to the back of mini-compact system.
Make sure the polarities (+and -) are correct.
R
Position of the DVD Player
•
Place it on a stand or cabinet shelf,
or under the TV stand.
Speakers L
R
• Place these speakers in front of your listening
position, facing inwards (about 45°) toward you.
• Place the speakers so that their tweeters will be
at the same height as your ear.
Directions in Installing Speaker
•
Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause
performance degradation of the speaker.
•
Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident
caused by falling of the speaker.
•
Do not take the speaker near from TV or computer monitor.
The speaker near the TV or computer monitor may influence the quality of the screen display.
11
L
Selecting the Listening Position
The listening position should be located about 2.5 to 3
times the distance of the TV's screen size away from the
TV. Example: For 32" TVs 2~2.4m (6~8feet)
For 55" TVs 3.5~4m (11~13feet)

Connecting the Video Out to your TV

Choose one of the four methods for connecting to a TV.
METHOD 2
METHOD 1 : HDMI ....... (Best Quality)
Connect the HDMI cable(not supplied) from the HDMI OUT jack on the back of the DVD Player to the HDMI IN jack
on your TV.
METHOD 2 : Component Video ....... (Better Quality)
If your television is equipped with Component Video inputs, connect a Component video cable(not supplied) from
the Component Video Output (Pr, Pb and Y) jacks on the back of the DVD Player to the Component Video Input
jacks on your TV.
COMPONENT SELECT Function
1. With the main unit turned off, press and hold the COMPONENT SEL. button on the remote control for over 5 seconds.
• <Y Pb Pr> and<RGB> will appear in the display.
2. Press the COMPONENT SEL. button shortly to select <Y Pb Pr> to set the main unit to COMPONENT mode.
METHOD 4
METHOD 3
(supplied)
METHOD 1
12