Installing Batteries In The Remote Control; Connections; Connecting Vhf And Uhf Antennas - Samsung PN50A550 User Manual

Installing Batteries in the Remote Control

1 Lift the cover at the back of the remote control upward as shown in the figure.
 Install two AAA size batteries.
➢ Make sure to match the "+" and "–" ends of the batteries with the diagram inside the
compartment.
➢ Using the remote control with the ON/OFF( ) light button set to On will reduce the
battery usage time.
※ Use alkaline batteries for the remote control.
 Close the cover as shown in the figure.
➢ Remove the batteries and store them in a cool, dry place if you won't be using the
remote control for a long time. The remote control can be used up to about 23 feet
from the TV. (Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn't work, check the following:
➢
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power cut, or is the power cord unplugged?
5. Is there a special fluorescent light or a neon sign nearby?

Connections

Connecting VHF and UHF Antennas

Ifyourantennahasasetofleadsthatlooklikethis,see"Antennaswith300ΩFlat
Twin Leads" below.
Ifyourantennahasoneleadthatlookslikethis,see"Antennaswith75ΩRound
Leads".
If you have two antennas, see "Separate VHF and UHF Antennas".
Antennaswith300ΩFlatTwinLeads
If you are using an off-air antenna (such as a roof antenna or "rabbit ears") that
has300Ωtwinflatleads,followthedirectionsbelow.
1 Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not
supplied).
Use a screwdriver to tighten the screws.

Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennaswith75ΩRoundLeads
1
Plug the antenna lead into the ANT IN terminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must
combine the two antenna signals before connecting the antennas to the TV. This
procedure requires an optional combiner-adaptor (available at most electronics
shops).
1 Connect both antenna leads to the combiner.
 Plug the combiner into the ANT IN terminal on the bottom of the back panel.
English - 
ANT IN
ANT IN
UHF
VHF
UHF
VHF
ANT IN