Advertisement
Quick Links
Assembly Instructions
CZ-680 massage chair arrives in three boxes. The base is packed in box 1, the backrest is packed
1
in box 2, and the side boards are packed in box 3. As pictured below.
1
2
Base
(Box 1 of 3)
Box 1:The Base
2
2
Backrest
(Box 2 of 3)
Box 2: Backrest
Open box 1 and remove all the packing materials. Take the base out of the box and get rid
2
of the plastic bag which covers the base. As pictured below.
1
Base
(Box 1 of 3)
3
Take the tablet holder from the footrest, remove the packing material and set aside.
The accessory box includes the power cord, user manual, instruction manual, warranty card, and arm
hardware. As pictured below.
3
Side Panel
4
(Box 3 of 3)
Box 3: Side Boards
2
3D PRO
CZ-680
3D PRO
3D PRO
CZ-680/ZEN 3D PRO
USER MANUAL CZ-680/ZEN 3D PRO
1
Advertisement
Related Manuals for DREAMSEAT CZ-680
Summary of Contents for DREAMSEAT CZ-680
- Page 1 Assembly Instructions CZ-680 massage chair arrives in three boxes. The base is packed in box 1, the backrest is packed in box 2, and the side boards are packed in box 3. As pictured below. Base (Box 1 of 3)
- Page 2 Cut the cable tie, which is used to secure the backrest actuator while shipping. Preferably using two people, carefully set the backrest on the cradle points on the base. Remove the protective material that is wrapped on the backrest actuator. Remove the cotter pin With the backrest in a vertical position, ensure it properly engages to the base.
- Page 3 Connect the backrest 4-way air hose connecter to the air pump box. Recline the backrest until it locks into position. Locate the connecter on the inflator pump box. The air hose must be upward. Open box 3 and remove the two side boards. Locate the two zipper heads at bottom edge of the Locate connector on PCB tray.
- Page 4 Connect the air hose to their appropriate connectors. Carefully attach the side board onto the Remove the protective cloth strips on the backrest pad and attach the backrest pad onto base. Align and insert the two metal bars on the base into the holes under the metal plate. As pictured backrest.
- Page 5 Attach the remote control holder onto right side armrest. Then attach the tablet onto the holder. As pictured below. Connect the chair to a power supply, then turn on the power switch. Now you can enjoy your massage chair! Locate the power switch...
Need help?
Do you have a question about the CZ-680 and is the answer not in the manual?
Questions and answers