Solight RNUB125 Quick Start Manual

EN RNUB125
Cordless angle grinder
The RNUB125 Cordless Angle Grinder uses a new generation, high quality, carbon-free motor to power it, which has a significantly
longer life than the carbon motors used previously. Please read the following instructions carefully and follow them to ensure that the
product serves you safely and to your full satisfaction. Avoid unprofessional handling of this tool, and always observe the electrical
appliance use policy. Keep the instruction manual carefully. Never expose to environments with high humidity, avoid contact of the
product with liquids.
TECHNICAL PARAMETERS
Model
Operating voltage
Engine
Speed without load
Rated power
Grinding wheel specifications
Battery type
Battery capacity
SAFETY MEASURES
Read and follow the following instructions.
Failure to follow all instructions below may result in electric shock, fire, or serious personal injury.
SAFETY RULES FOR ANGLE GRINDER
• Always wear safety glasses and earplugs. Other protective equipment such as dust respirators, gloves, hard hats and aprons
should also be used.
The protective collar and handle must be firmly attached.
•
• Do not use a disc that is damaged or has cracks.
CLEANING AND MAINTENANCE
• Remove the battery before performing any service or maintenance.
• After about 10 hours of use, the collar should be removed and the grinder cleaned of dirt.
Store in a dry and clean environment at room temperature.
•
• More complex repairs may only be carried out by experts at the Solight holding s.r.o. service centre.
USING
Wear appropriate clothing, work gloves and eye protection when using this equipment. Before each use, make sure the equipment is
working properly by running it briefly "on empty".
When the grinder is put into operation, make sure to keep your hands at least 15 cm away from the grinding area.
•
• If the grinder shakes or vibrates during use, it is the result of a defective wheel or a faulty mounting.
• Do not use the sander in rain or in explosive or flammable environments.
Remove the battery when not in use.
•
• If the performance of the grinder decreases, check the battery charge or recharge it.
RNUB125
21 V
Carbonless engine
7000 RPM
1100W
Outer diameter max. 125 mm, inner diameter
22 mm
Li-Ion battery
4.0 Ah
Part of the package
1pc handheld cordless angle grinder
1pc 21V 4Ah Li-Ion battery
1pc charger
1pc instructions
1pc key
1pc collar
1pc handle