1. Manuals
  2. Brands
  3. Uniteck Manuals
  4. Battery Pack
  5. UNIBAT AGM
  6. Manual

Uniteck UNIBAT AGM Manual

Lead carbon battery
Hide thumbs

Advertisement

Table of Contents

Batterie AGM plomb carbone
FR
Battery AGM lead carbon
EN
Batería AGM plomo carbono
ES
Batteria AGM piombo carbonio
IT
Charge impérative sous 24H après décharge profonde
Dommage non couvert par la garantie
!
Imperative charge after all deep discharge
Damage not covered under warranty
Carga imperativa después de toda descarga profunda
Deterioro no cubierto por la garantía
UNIBAT
AGM CARBONE
www.uniteck.fr
FR
EN
ES
p.2-16
p.17-31
p.32-46
www.uniteck.fr
25/10/2018
CO00358

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UNIBAT AGM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Uniteck UNIBAT AGM

  • Page 1 Batterie AGM plomb carbone Battery AGM lead carbon p.17-31 Batería AGM plomo carbono p.32-46 www.uniteck.fr Batteria AGM piombo carbonio Charge impérative sous 24H après décharge profonde Dommage non couvert par la garantie Imperative charge after all deep discharge Damage not covered under warranty Carga imperativa después de toda descarga profunda...
  • Page 2 Recycle and Dispose of Used Batteries Used batteries contain valuable recyclable materials. They must NOT be disposed of with domestic waste. Modes of return and recycling shall conform to the prevailing regulations in operation at the site where the battery system is located. www.uniteck.fr 17/46...

  • Page 3: Precautions Before Installation

    Thanks to their unique internal design, UNIBAT AGM batteries can accept discharge rates of up to 80% to use the maximum of the available energy. Their weak self-discharge guarantees a good stability over time.
  • Page 4 High ambient temperatures reduce the lifespan of batteries. On the contrary, weak temperatures reduce available capacity. Thus, in order to make the most of Unibat batteries performances (number of cycling, lifespan, available capacity), you need to use it in an environment with a temperature between 20°C and 25°C. www.uniteck.fr 19/46...
  • Page 5 Do not couple batteries of different ages and different technologies. If there is the same capacity, prefer one powerfull battery than 2 small batteries connected in parallel. Spread a thin layer of contact lubricant on terminals and on roll thread. Avoid all contact with the battery box. www.uniteck.fr 20/46...
  • Page 6 A wrong tightening can interfere with your charger or your charging system. It means that it can create irregular performances and/or damage your battery. Once all bolts are well tightened, put the isolator cap to protect against all accidental contacts. www.uniteck.fr 21/46...

  • Page 7: Warning Before Using

    Warning: the same phenomenon can also come from a charging issue. It is the case when the noise is present with tensions higher than 15.5V. It is a problem from voltage regulation or too powerful charge from your charging system (alternator/battery charger, solar…). If it happens, disconnect your charging system and make appropriate corrections. www.uniteck.fr 22/46...

  • Page 8: Charging Steps

    Charging voltage data are indicated for an ambient temperature of 25°C. Below this temperature it is recommended to adjust voltage threshold at +/- 30mV per degree. Ex.: Ambient temperature of 35°C = 35°C – 25°C x 0,003V = voltage must be reduced by 0.03V. www.uniteck.fr 23/46...
  • Page 9 The only way to know the real capacity of your battery is to charge it then unload it and to measure its restored capacity with a tester such as EMROL ones. www.uniteck.fr 24/46...
  • Page 10 (cut advised for low 5H-2H <20 min voltage) 10,5V 80AH 100-250W 500W 1000W 100Ah 120-300W 600W 1200W 150Ah 180-450W 900W 1800W 200Ah 240-600W 1200W 2400W 220Ah 250-650W 1300W 2500W 300Ah 350-900W 1800W 3600W 400Ah 450-1200W 2400W 4800W 600Ah 720-1800W 3600W 7200W www.uniteck.fr 25/46...
  • Page 11 For example, for a temperature of -10°C with an unload rate of 20% of the capacity (0,2C), the available capacity will be 70%. Also, in order to completely enjoy Unibat batteries performances, it is recommended to have an ambient temperature between 20 and 25°C. www.uniteck.fr 26/46...
  • Page 12 10 11 12 13 14 15 23 24 Months The self-consumption is more important with high temperature. Also, in order to avoid deep unload after period of non-use, it is recommended to charge your battery regularly (every 3-6 months). www.uniteck.fr 27/46...

  • Page 13: Warning And Advice

    Caution! Before using, read the Caution explosive gases, avoid sparks and instruction manual open flames. Product under selective Choose a sheltered space with adequate collection- Do not throw away ventilation or an especially equipped space. with household waste. www.uniteck.fr 28/46...

  • Page 14: Technical Specifications

    High resistance polypropylene Operating temperature -15°C ~ + 40°C Dimensions (l x h x p) 368 x 219 368 x 219 x172 522 x 221 x 522 x 221 x 240 x172 mm 240 mm Weight 27kg 29,5kg 43,5kg 58,5kg www.uniteck.fr 29/46...

  • Page 15: Compliance Statement

    COMPLIANCE STATEMENT UNITECK testifies that the battery described in this manual: UNIBAT AGM are manufactured in compliance harmonized standards: - Lead stationary battery: EN 60896-21 /EN 60BATTERIES STATIONNAIRE896-22 - Accumulator for the storage of renewable energy: EN 61427-1 : 2013 / EN 61427-2: 2016 CE date of tagging: january 2019.

  • Page 16: Warranty

    Remark: all actions you can find bellow will cancel the warranty: - non-respect of installation instructions, using and maintenance - association of several batteries of different types or ages without UNITECK validation. - Charging system non-adapted to the battery - Important discharges without reload within 24h.

This manual is also suitable for:

Unibat 80.12 agmUnibat 100.12 agmUnibat 150.12 agmUnibat 220.12 agm

Table of Contents