Summary of Contents for Getinge ArjoHuntleigh Maxi Twin
- Page 1 Maxi Twin Scale INSTRUCTIONS FOR USE 0086 04.KT.03_5US.CA September 2014 ...with people in mind...
- Page 2 © Arjo Hospital Equipment AB 2009 ArjoHuntleigh products are patented or patent pending. Patent information is availa- ble by contacting Arjo Hospital Equipment AB. Our policy is one of continous development, and we therefore reserve the right to make technical alterations without notice. The content of this publication may not be copied either whole or in part without the consent of Arjo Hospital Equipment AB.
-
Page 3: Table Of Contents
Contents Before use ..................4 Display and Control function............. 4 Weighing.................... 5 Switch on/Weighing..............5 Taring ................... 5 Changing the unit kg/lb (USA -Canada only) ........6 Weighing methods ................6 Switching off..................7 Error messages ................... 7 Cleaning instructions ................. 7 Changing batteries ................ -
Page 4: Before Use
Before use Calibration Weighing Scales within the EU are sealed and ver- ified and any calibration or re-verifica- The scale is calibrated from factory and Weight is displayed in kg/lbs. tion has to be done by a notified body. ready for use. If the scale needs to be recalibrated, please contact your Arjo- Huntleigh representative for support. -
Page 5: Weighing
Weighing The scale is ready to use about 10 seconds after it is switched on. During this time, the scale must neither be moved nor loaded. Switch on/Weighing Switch on the scale Display segment test (- 5 seconds) Hold Tare >... -
Page 6: Changing The Unit Kg/Lb (Usa -Canada Only)
Changing the unit kg /lb (Only applies to non-verifiable scales, USA and Canada) Switch on the scale and wait - 10 seconds Unit kg > 0 < Keep pressed for -5 seconds Unit Lb (American pound) > 0 < The same method is used to change from Lb to kg. The last unit set is retained even when the scale is switched off. -
Page 7: Switching Off
Switching off Press the ON/OFF button to switch off the scale. The scale has an automatic SHUT OFF after approximately 1 minute. Error messages Scale overloaded Please comply with the nominal (rated) load for the scale (see identification plate on the back of the device). Switch OFF and ON again. -
Page 8: Labels And Indicators
Labels and indicators On the data label you will find the Verification labels • HBM sealing; During the initial ver- following information: ification, this seal is used to protect After verification the following labels are to be found on the scale: scales of Accuracy Class III from •... - Page 9 GETINGE GROUP is a leading global provider of products and systems that contribute to quality enhancement and cost efficiency within healthcare and life sciences. We operate under the three brands of ArjoHuntleigh, GETINGE and MAQUET. ArjoHuntleigh focuses on patient mobility and wound management solutions. GETINGE provides solutions for infection control within healthcare and contamination prevention within life sciences.
Need help?
Do you have a question about the ArjoHuntleigh Maxi Twin and is the answer not in the manual?
Questions and answers