Acuity Brands Lighting HOLOPHANE HAZARDOUS WALLPACK IV Installation And Maintenance Manual

SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
•
•
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and
other hazards please read all warnings and instructions included with and on the luminaire box and all luminaire labels.
•
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
•
Installation and service of luminaires should be performed by a qualified licensed electrician.
•
Maintenance of the luminaires should be performed by person(s) familiar with the luminaires' construction and operation and
any hazards involved. Regular luminaire maintenance programs are recommended.
•
It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient dirt
level and minimum light output which is acceptable to user. Refractor/lens should be washed in a solution of warm water
and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry. Should optical assembly become
dirty on the inside, wipe refractor/lens and clean in above manner, replacing damaged gaskets as necessary.
•
DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have been damaged
during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.
•
Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
•
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to
meet in connection with installation, operation, or maintenance. Should further information be desired or should particular
problems arise which are not covered sufficiently for the purchaser's or owner's purposes, this matter should be referred to
Acuity Brands Lighting, Inc.
WARNING
RISK OF ELECTRIC SHOCK
✓ Disconnect or turn off power before
installation or servicing.
✓ Verify that supply voltage is correct by
comparing it with the luminaire voltage
rating marked on nameplate.
✓ Make all electrical and grounded
connections and use required wiring method
for the specific Hazardous Location in
accordance with the National Electrical Code
(NEC) and any applicable local code
requirements.
✓ All wiring connections should be capped
with UL certified wire connectors.
CAUTION
RISK OF INJURY
✓ Wear gloves and safety glasses at all times
when removing luminaire from carton,
installing, servicing or performing
maintenance.
✓ Avoid direct eye exposure to the light source
while it is on.
LED IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
WARNING
RISK OF BURN
✓ Allow luminaire to cool before handling. Do
not touch enclosure or light source.
✓ Follow all warnings, recommendations and
restrictions for: mounting locations/methods
in this installation instructions document.
CAUTION
RISK OF FIRE
✓ Keep combustible and other materials that
can burn, away from lamp/lens.
✓ Do not operate in close proximity to persons,
combustible materials or substances
affected by heat or drying.
IM-400-A