Skullcandy Indy Evo S2IVW-N744 / S2IVW-N740 Pairing Manual

Table of Contents

DO THIS FIRST TO PAIR

Remove earbuds from package, place them in charging case, and make sure both earbud LEDs turn red.
Remove earbuds from charging case. This will automatically put them in pairing mode. (Note: only the left bud will flash red and blue.)
Open your list of available Bluetooth devices and select "Indy Evo." Earbud LEDs will turn blue when connected. Be sure to select "Pair" or "OK" when you see the Bluetooth pairing request.

For additional features, download the Skullcandy app.

If you ever have an issue pairing your earbuds, follow these steps:

Unpair the buds from your phone or device.
Touch and hold the main button on each bud for 6 seconds to manually turn them both off.
Touch and hold the main button on each bud for 10 seconds to completely reset them (this will power them on and off again).
Place buds back in the case until both LEDs show red, and then remove from case. Both buds will automatically power on and the LEDs will flash blue while they sync to each other.
A tone will indicate when the buds have synced. The LED on the left bud will flash blue and red and a voice will say "pairing" when the buds start connecting to your phone or device.
Look for Indy Evo in your list of available Bluetooth devices. Make sure it only appears once and select it.
Select all "Pair" or "0K" prompts that will pop up on your screen.
Once successfully paired, a voice will say "connected" and you'll see Indy Evo twice on your available or paired devices list.

Questions?
Skullcandy.com/support/IndyEvo