Panasonic Palmcorder IQ PV-A226 Operating Instructions Manual page 4

Important Safeguards
15. Power Lines — An outside antenna system should b. if any liquid has been spilled onto, or objects
not be located in the vicinity of overhead power have fallen into the video unit.
lines or other electric light or power circuits, or c. tf the video unit has been exposed to rain or
where it can fall into such power lines or circuits. water.
When installing an outside antenna system, d. If the video unit does not operate normally by
extreme care should be taken to keep from
totlowi: i n g instruct . Adj H
touching such power Iines or circuits as contact owing tie POSTAL lons; Adjust only
those controls that are covered by the operating
with them might be fatal. instructions, as an improper adjustment of other
16. Overloading — Do not overload wall outlets and controls may result in damage and will often
extension cords as this can result In a risk of fire or require extensive work by a qualified technician
electric shock. to restore the video unit to its normal operation.
17. Objects and Liquids — Never push objects of any 6. If the video unit has been dropped or the cabinet
kind into this video unit through openings as they has been damaged.
may touch dangerous voltage points or short out f. When the video unit exhibits a distinct change in
parts that could result in a fire or electric shock.
Never spill liquid of any kind onto the video unit.
18. Servicing — Do not attempt to service this video
unit yourself as opening or removing covers may
expose you to dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
performance — this indicates a need for service.
20. Replacement Parts — When replacement parts are
required, be sure the service technician has used
replacement parts specified by the manufacturer or
have the same characteristics as the original part.
Unauthorized substitutions may result in fire,
19. Damage Requiring Service — Unplug this video electric shock or other hazards.
unit trom the wali outlet and refer servicing to 21. Safety Check— Upon completion of any service or
qualified service personnel under the following repairs to this video unit, ask the service technician
conditions: to perform safety checks to determine that the
a. biles = power-supply cord or plug is video unit is in safe operating order.
maged.
Precautions
USE 4 LOCATION
* TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designed
for outdoor use, however it Is not designed to sustain direct exposure to water, raln, sleet, snow, sand, dust, or a
direct splashing from a pool or even a cup o! coffee. This action could permanently damage the internal parts of
your Camcorder. Do not attempt to disassemble this unit. There are no user serviceable parts inside. Unplug
your Camcorder from the power supply before cleaning.
* DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS
* DO NOT LEAVE THE PALMCORDER WITH THE EVF AIMED DIRECTLY AT THE SUN AS THIS MAY
CAUSE DAMAGE TO THE INTERNAL PARTS OF THE EVF
+ DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, in direct sunlight,
inside a closed car, next to a heater, etc... This action could permanently damage the intemal parts of your
Camcorder.
» AVOID SUDDEN CHANGES IN TEMPERATURE ... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
* DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.
e STORAGE OF YOUR CAMCORDER ... Store and handle your Camcorder in a manner that will not subject it to
unnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive plck-up device which
could be damaged by improper handling or storage.
CARE
» TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorder
body.
+ TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
* TO PROTECT THE FINISH OF YOUR CAMCORDER ... Before handling your Camcorder, make sure your
hands and face are free trom any chemical products, such as suntan lotion, as it may damage the finish.
4