Dream On Me ZAZU 384-GP - Baby Swing Manual

WARNINGS

Failure to follow these warnings and the instructions could result in serious injury or death.

PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFETY OF YOUR CHILD.

• Always secure infant in restraint system provided.
• Never leave infant unattended in the swing.
• For ages 0-6 months
• The maximum weight for this product is 25 lbs.
• DO NOT move or lift the product from the toys or canopy.
• DO NOT move or lift the product when the child is sitting in it.
• DO NOT hang other items from the canopy except for the toys included in this product.
• DO NOT place the product at an elevated surface (table, stairs, or any other elevated surface) to reduce fall risk.
• Its dangerous to use this product on an elevated surface.
• DO NOT use this product on anything soft such as a sofa or bed to avoid falling and asphyxiation.
• If the child is able to sit up unassisted, please use this product under adult supervision.
• This product is not classified as a toy
• DO NOT open or fold the product with the child inside of it.
• When using the music player, please make sure to start at a low volume and to raise the volume gradually.
• DO NOT use if any parts are missing or broken. NEVER substitute parts.
• Keep the product away from fire
• Discontinue use of product when infant intends to climb out (approximately 9 months).
• FALL and STRANGULATION HAZARDS: Infants have suffered head injurie falling from swings and have strangled in straps.
• ALWAYS use resraints. Adjust to fit accordingle
• Stay near and watch infant during use. This product is not safe for unsupervised use or unattended sleep.

www.dreamonme.com/help

PARTS

If there are any missing parts, please contact Dream On Me before using the product.

Baby Swing Setup

1a. Locate the battery compartment in the base. Remove the battery compartment cover and undo screw using a Phillips screwdriver. Install 4 "AAA" batteries; match the polarity indicated inside the battery compartment.

1b. Re-attach battery compartment cover and fasten using the screw.

Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Remove batteries before storing this product.

2. Insert the Seat Frame into the Base. Push down until you hear the seat click into the base.
   

Canopy Attachment

3a. Attach the Canopy to the Seat Frame mounting points, as shown.

3b. Pull down the back of the Canopy and wrap it around the top of the Seat Frame.

Toy Attachment

4. Attach toys to Canopy loops using hook and loop fasteners.
   

Possible entanglement or strangulation injury. DO NOT hang other items from the canopy except for the toys included in this product. Toys are intended for visual stimulation and are not intended to be grasped by the child. Always attach all provided fasteners (strings, straps, clamps, etc.) tightly according to the instructions. Check frequently..

5. The mosquito net can be extended and wrapped around the bottom edge of the Seat Frame.
   

Swing Seat Lock

6. The Seat can be locked in a forward facing position. Locate the swing lock on the front of the unit, as shown. Push down to lock or pull up to unlock.
   

Seat must be unlocked before starting the Swing motion.

Buckling the Infant

7a. Check to make sure the harness is unbuckled and place the infant in the seat. Wrap the harness straps around the shoulders and waist, as shown. Pull the crotch strap pad up between the infants legs.

7b. Insert the harness clips into the harness buckle and click to fasten.

8a. Pull on the adjustment buckles to tighten or loosen the straps. Make sure the shoulder harness and waist belt straps are snug around the infant.

8b. Fold down the harness buckle cover and secure with hook and loop.

Operating Baby Swing

1. Power On/Off: Press the to turn ON and OFF. The indicator light will be lit when the power is ON.
2. Swing Gear: Press the to change the swing settings. There are 5 swing speeds indicated by the lights.
   Note: Check to make sure the swing lock is released before using this function.
3. Time: Press the to cycle through the swing times (8, 15, 30 minutes).
4. USB: This product can support a USB drive to play music. Insert the USB drive and press the . See USB port location section.
5. Music:
   1. Press the to play music.
   2. Press and hold for 2 seconds to play the next song to play.
6. Volume: Press the to increase volume. Press the to decrease volume.
7. Bluetooth: Connect to Bluetooth by selecting "BT-BABY" on your smartphone. The will light up when Bluetooth is connected.

Power Adapter / USB / Remote Storage

1. Insert the Power Cord into the base and plug the adapter into the wall.
   
2. The USB port can be used to play music.
   
3. The remote control can be stored in the back of the seat, as shown.
   

Removing the Seat

Care and Maintenance

Occasionally check your product for loose screws, worn parts, torn material or stitching. Replace or repair the parts as needed. Use only Dream On Me replacement parts.

• Keep this product in a cool dry place. If this product happens to get wet, wipe with a dry cloth and allow to air-dry completely.
• Excessive exposure to direct sunlight or heat could cause fading of fabric or warping of parts.
• To clean this product, wipe clean with damp cloth use only household soap and cool water. DO NOT BLEACH. DO NOT submerge toys in water.
• Seat Pad can be removed from the seat frame and washed by hand in cold water, or machine washed on gentle cycle.